PRE-OPERATING Instructions, Ground Fault Interrupter

SAFETY INFORMATION

Continued

29.Use only in accordance with the local ordi- nances and codes.

30.This product is not to be used as the sole support for an umbrella. Umbrella must be supported by a table.

31.Do not use or install umbrella into product at temperatures below freezing. A damaged product could result in the risk of ﬁre, electric shock and injury to persons.

32.Do not use this at any elevation above ﬂoor level. Do not place on a table.

33.Locate product so “ON” light can be easily seen 10 ft (3.05 m) around and 5 ft (1.52 m) above.

34.If a table cloth is used on the table above the prod- uct, secure it to prevent movement due to wind.

35.Do not use in temperatures above 75° F (28.9° C). Nuisance tripping of manual reset thermal protector can occur.

36.Take precautions to prevent spilling drinks on product.

37.If the product will not operate, see speciﬁc instructions in Troubleshooting, page 5.

38.Save these instructions for future reference.

This product contains and/or generates chemicals known to the state of California to cause cancer or birth defects, or other reproductive harm.

PRE-OPERATING

INSTRUCTIONS

GROUND FAULT INTERRUPTER

•Since 1971 the National Electric Code (NEC) has required Ground Fault Circuit Interrupter devices on all outdoor circuits.

•If your residence was built before 1971, check with a qualiﬁed electrician to determine if a Ground Fault Circuit Interrupter protector exists.

•Do not use this product if the circuit does not have a GFCI protection.

•Do not plug this product into an indoor circuit.

•Typical accepted GFCI devices are shown in Figure 1.

•Avoid the use of an extension cord. Extension cord may overheat and cause risk of ﬁre. If you must have an extension cord, the cord shall be minimum size of 14 awg and not rated less than 1875 watts. Use only 3 wire cord type (3 prong plug) marked for outdoor use.

RESET

TEST

		WARNING
Test and




Reset
Reset	GFCI Cord
Buttons	GFCI Cord
	Adapter
	Figure 1 - GFCI Options

PLUG ADAPTER

IMPORTANT: This product must be used on a grounded supply circuit.

An adapter as shown in Figure 2 is available for connecting three-prong grounding type plugs to two-slot receptacles. The green grounding lug extending from the adapter must be connected to a permanent ground such as a properly grounded outlet box.

Metal

Screw

Cover of

Grounded

Outlet Box

Figure 2 - Plug Adapter

113612-01B