CLEANING
DURING SEASON CARE
Always unplug the product before moving or cleaning.
1.Do not disassemble. Carefully wipe the exte- rior of unit with a soft, damp cloth.
2.After cleaning, be sure to completely dry the unit with a cloth or towel.
AFTER SEASON CARE
Store product indoors in a dry location. No main- tenance is required for this product.
TROUBLESHOOTING
CAUTION: Risk of electric shock.Donotopen.Nouserservi- cable parts inside. Take heater to an authorized service center.
6.Lightly push red button to reset switch.
7.Replace removed plug in hole. Perform a trial operation.
8.If repeated resetting of the thermal limit switch is required, have the product serviced by an authorized service center.
Push Rod
Access to
Thermal
Limit Switch
Figure 4 - Resetting Thermal Limit Switch
If your product fails to operate:
1. Make sure the electrical outlet GFCI or circuit |
WIRING DIAGRAM
| breaker and extension cord is working. |
2. | Check for operation of tip switch. The ON/ |
| OFF switch light can be on but the tip switch |
| OFF. Move product until a “click” is heard. |
| To prevent damage of tip switch post, do not |
| slide product. |
3. | Look for obstructions around fan. If you find |
| an obstruction, turn the product OFF and |
| UNPLUG THE PRODUCT. Have the product |
| serviced by a qualified individual. |
4. | Check for tripped thermal protector. Motor |
| and heating element do not operate. Wait 10 |
| minutes for product to cool. Push reset button. |
| See Thermal Limit Switch below. |
POWER PLUG
120V 60Hz
| GREEN |
WHITE | BLACK |
| ON/OFF |
| SWITCH |
| N L |
| BLACK |
| N L |
| MANUAL RESET |
TIP SWITCH | THERMAL LIMIT |
SWITCH | |
| BLACK |
|
|
THERMAL LIMIT SWITCH
If product is used in temperatures below 75° F (28.9° C), the limit switch should not require resetting unless there is a malfunction. If a mal- function does occur, have the product serviced by an authorized service center.
Resetting Thermal Limit Switch
1.Unplug product.
2.Allow product to cool.
3.Turn product upside down.
4.Remove plug on bottom.
5.Insert provided plastic push rod through hole and guide to small red button on thermal limit switch (see Figure 4). A flashlight will improve visability.
WHITE
HEATING
WHITE ELEMENT BLACK
MOTOR
GREEN
BLACK
www.desatech.com | 5 |