ENGLISH
2.Turn cornering door locking lever (l) counterclockwise one full rotation. Grasp the corner door (m) and rotate open.
3.Place hands away from the wheel area and position yourself so the open underside of the shroud is facing away from you.
4.Turn the tool on and allow the tool to reach full speed before touching the tool to the work surface.
5.Place the wheel onto the work surface and move the grinder from right to left to cut around the inside corner for best dust collection.
6.Remove the tool from work surface before turning tool off. Allow the tool to stop rotating before laying it down.
7.Close the corner door and lock in place using the cornering door locking lever (l).
DUST EXTRACTION (FIG. 7)
WARNING: Use only power tools recommended by DEWALT with this attachment.
For more information about DEWALT power tools compatible with this attachment, please contact one of our authorisec services centers, listed on the back cover, or refer to the full details of our
WARNING: This attachment MUST BE used with a dust extractor system. ALWAYS wear certified safety face or dust mask.
NOTE: Ensure hose connection is secure.
NOTE: The amount of dust retained by the dust extractor vacuum is dependent on its filter system. Refer to the dust extractor vacuum instruction manual for more information.
All DEWALT dust collection shrouds are designed to work with the DEWALT Airlock DWV9000 connector.
1.Attach the DWV9000 connector (s) to your dust collector hose (t).
2.Unlock the DWV9000 connector (s) and slide onto dust port (h).
3.Lock the DWV9000 connector (s) to secure.
TRADITIONAL DUST EXTRACTOR VACUUM HOSES (FIG. 7)
Attach recommended dust extractor vacuum hose to dust port (h).
Prior to Operation
•Install the guard and appropriate disc or wheel. Do not use excessively worn discs or wheels.
•Be sure the inner and outer flanges are mounted correctly.
•Make sure the disc or wheel rotates in the direction of the arrows on the accessory and the tool.
OPERATION
Instructions for Use
WARNING: Always observe the safety instructions and applicable regulations.
WARNING: To reduce the risk of serious personal injury, turn tool off and disconnect tool from power source before making any adjustments or removing/installing attachments or accessories. Before reconnecting the tool, depress and release the switch to ensure that the tool is off.
WARNING:
•Ensure all materials to be ground or cut are secured in place.
•Apply only a gentle pressure to the tool. Do not exert side pressure on the disc.
•Avoid overloading. Should the tool become hot, let it run a few minutes under
Proper Hand Position (fig. 8)
WARNING: To reduce the risk of serious personal injury, ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal injury, ALWAYS hold securely in anticipation of a sudden reaction.
Proper hand position requires one hand on the side handle (c), with the other hand on the body of the tool, as shown in figure 8.
Slider Switch (fig. 1)
WARNING: Before using the tool, check that the side handle is tightened securely.
CAUTION: Before connecting the tool to a power supply, be sure the switch is in the off position by pressing the rear part of the switch and releasing. Ensure the switch is in the off position as described above after any interruption in power supply to the tool, such
40