Country Home Products 6-TON operating instructions Flat surface facing forward

Page 16

Power Cord Keeper

Figure 5

Figure 6

Figure 7

5.Wrap the Power Cord around the Power Cord Keeper (Figure 5).

6.Insert a Wheel Axle all the way into the hole at the rear of the frame (Figure 6) and install a 6mm Bolt (Figure 7). Tighten the Bolt with the 10mm Wrench (Figure 7).

7.Repeat step 5 for the other rear Wheel on the opposite side of the machine.

8.Remove the Operating Handle Retaining Screw and Washer from the end of the Handle Shaft.

9.Insert the Operating Handle Shaft into the recessed hole on top of the cylindrical shaft protruding from the right rear side of the machine. Thread the Retaining Bolt with Washer up through the hole in the bottom of the cylindrical shaft and into the Operating Handle shaft (Figure 8).

10.While holding the Operating Handle Grip tight with the flat surface of the Operating Handle Grip facing forward, tighten the Retaining Bolt using the 6mm Hex Wrench (Figure 8).

Flat surface facing forward

Figure 8

BEFORE ATTEMPTING TO OPERATE YOUR NEW DR 6 -TON ELECTRIC WOOD SPLITTER, READ THE SECTION TITLED “BEFORE STARTING THE ELECTRIC MOTOR” ON PAGE 13 IN THE SAFETY & OPERATING INSTRUCTIONS MANUAL.

If you have questions, please call one of our Technical Support Representatives TOLL-FREE:

1-800-DR-OWNER (376-9637).

12 DR® WDS 6.4, 6 -TON ELECTRIC WOOD SPLITTER

Image 16

Contents Page Meigs Road Vergennes, VT Toll-free phone 1-800-DR-OWNER Fax Table of Contents Iv DR WDS 6.4, 6 -TON Electric Wood Splitter Introducing the DR 6 -TON Electric Wood Splitter Conventions used in this manualSpecifications for the DR 6 -TON Electric Wood Splitter 12,000 lbfGeneral Safety Rules LabelsProtecting Yourself and Those Around You Operating the Wood Splitter SafelySafety for Children Safety with Electric-Powered Machines Hydraulic Safety Additional Information and Potential Changes DR-OWNER DR 6 -TON Electric Wood Splitter Controls and Features Controls LabelTools and Parts Supplied Additional Tool RequiredFlat surface facing forward Operating Your DR 6 -TON Electric Wood Splitter Before Starting the Electric MotorTools Needed Inspect the area in which you will be workingDipstick and Hydraulic Fluid Port Splitting Safety Handle Logs only from the SIDES, Never by the EndsOperating the DR 6 -TON Electric Wood Splitter How to Free a Jammed Log from the Wedge Activate the Ram to push the Wedge underDR WDS 6.4, 6 -TON Electric Wood Splitter Maintaining the DR 6 -TON Electric Wood Splitter Regular Maintenance Checklist before each useBefore each season Sharpening the Wedge Adjusting the Hydraulic Fluid LevelTool Needed Electrical Connections End of Season and StorageDR WDS 6.4, 6 -TON Electric Wood Splitter Troubleshooting Troubleshooting TableHydraulic fluid leaking from the Ram or other external parts Parts LISTS, Schematic Diagrams and Warranty Parts List DR 6 -TON Electric Wood SplitterPart# Description 107 215451 215501 Fan Kit220361 Wheel Kit 220381 Carry Handle KitSchematic DR 6 -TON Electric Wood Splitter Optional Accessories TrayDR 6 -TON Electric Wood Splitter Daily Checklist for the DR 6 -TON Electric Wood Splitter