Cooper Lighting Pole Mount Icon Sheet 3, Attach Arm to Pole, Arm Rods Nut Plate Pole

Page 3

TM

INSTALLATION INSTRUCTIONS

IMPORTANT: READ CAREFULLY BEFORE INSTALLING FIXTURE.

RETAIN FOR FUTURE REFERENCE.

Pole Mounted Icon

Sheet 3 of 5

3/11/04 IMI-593

WARNING: Risk of Electric Shock. Disconnect power at fuse or circuit breaker before installing or servicing.

4.Attach Arm to Pole -

Slide the NUT PLATE into the POLE. Install the THREADED RODS through the holes in the POLE and into the NUT PLATE. Slide the ARM over the THREADED RODS. See Figure 4.

NOTE: Use of a thread locking compound (not supplied) is suggested where the THREADED RODS contact the NUT PLATE.

Arm

Rods

Nut Plate

Pole

Fig. 4

5.Attach Housing to Arm -

Remove the WIREWAY PLUG from the HOUSING. Move the fixture leads aside so the THREADED RODS may be accessed through the fixture HOUSING. See Figure 5a.

Feed the fixture wires through the ARM. Slide the HOUSING over the THREADED RODS and secure it with the PLAIN WASHERS, LOCK WASHERS and HEX NUTS. Torque HEX NUTS as follows:

Medium Icon (ICM) - 450 in-lbs., Small Icon (ICS) - 130 in-lbs. See Figure 5b.

WARNING

Risk of Personal Injury

Fixture may become damaged and/or unstable if not installed properly

Tighten all fixture components to their recommended torque values

NOTE: It may be helpful to use a deep socket when installing the HEX NUTS.

Re-install the WIREWAY PLUG into the wireway in the HOUSING.

Wireway Plug

Fig. 5a

These instructions do not claim to cover all details or variations in the equipment, procedure, or process described, nor to provide directions for meeting every possible contingency during installation, operation or maintenance. When additional information is desired to satisfy a problem not covered sufficiently for user’s purpose, please contact your nearest representative.

Customer First Center • 1121 Hwy 74 South • Peachtree City, GA 30269 IMI-593 AVU040206

Image 3
Contents Sheet 1 11/04 IMI-593Button Latches Push to Open Reflector Tabs Sheet 2 Power Supply Tray Thumb ScrewsArm Rods Nut Plate Pole Re-install the Wireway Plug into the wireway in the HousingSheet 3 Attach Arm to PoleArm Wireway DoorSheet 4 LinearReflector Power Supply Tray Outer Door Sheet 5Buttoning Up