FIGURE 7 | move to the next link, and tighten it to | |
sharpen each link. | ||
| ||
| FIGURE 9 |
Lock Stop (6)
6.Hold it at that position while you tighten the Lock Stop (6) so that the wheel will only go down to that point. See FIGURE 7.
7.Depending on the amount of material you wish to remove, tighten or loosen the Lower Knob (26) and set the Lock Nut. See FIGURE 5. The Lower Knob (26) has a Lock Nut which will determine how much material is removed. Once you set the Lock Nut, fully tighten the Lower Knob (26).
FIGURE 8
Limiting
Gauge
Handle
(34)
8.Lock the chain in the Sliding Guides (31) by turning the Handle (34). See FIGURE 8. The Handle (34) should be situated so that you can easily release and tighten it. You will need to release it each time you
9.If the chain has been repeatedly sharpened, the chain depth limiting gauges may need to be taken down with a flat file (not included). See FIGURES 8 & 9. File down each gauge so that they are at a lower level than the cutting teeth.
Sharpening
1.Put on your protective gear and make sure the immediate area is clear of bystanders.
2.Plug in the Power Cord (3) and push the Switch (5B) to turn on the machine.
SKU 93213 | For technical questions, please call | Page 11 |