Maximizing the life of your lamp
To ensure the longest and most efficient use of the lamp always wait between 10 to 15 minutes before
Failure to do so could result in premature aging of the lamp and failure to the electronics that drive it.
Never turn off the power to the unit while the lamp is striking. Always wait 15 minutes after powering on the fixture before powering down. Turning off the lamp during striking may permanently damage
the lamp.
Fuse Replacement
Disconnect the power cord before replacing a fuse and always replace with the same type fuse.
With a Phillips #2 screwdriver, unscrew the fuse holder from its housing. Remove the damaged fuse from its holder and replace with exact same type fuse. Screw the fuse holder back in its place and reconnect power.
The fuse is located inside this compartment. Remove using a Phillips #2 screwdriver.
FUSE
FasTap™ Voltage and Frequency adjustment
Warning! Remove power from mains prior to this operation
This fixture will operate with multiple voltage and frequency options. Depending on the power being supplied to the fixture, you may modify the connections on the terminal block. Please see the below instructions for modifying the settings.
1.Disconnect the fixture from the mains power.
2.Unscrew the 2 screws that hold the FasTap™ cover in place.
3.Unscrew the screw on the terminal block according to the desired voltage and frequency and retighten snugly as needed.
4.
115V50Hz
230V | 60Hz |
|
Legend™ 550 Spot User Manual | 9 | 1/11/2010 11:36 AM |