|
| Setup |
Gobo Replacement | 1. Turn the product off and disconnect from power. | |
| 2. | Unlock the gobo cover and slide it away. |
| 3. | Separate the gobo plate away from the gobo wheel by pushing it toward the front of |
|
| the moving head (direction 1 in the diagram). Be careful not to push the gobo out of |
|
| the gobo plate. |
| 4. | Extract the gobo plate by pulling it outward (direction 2 in the diagram). |
| 5. | On a flat surface, remove the expansion ring that holds the gobo in place and |
|
| remove the gobo from the gobo plate. |
| 6. | Insert a new gobo and hold it in place with the expansion ring. |
| 7. | Slide the tip of the gobo plate under the pressure plate near the center of the gobo |
|
| wheel. |
| 8. | Push the gobo plate inwards. DO NOT force the gobo plate into the gobo wheel slot. |
|
| If correctly installed, the gobo plate should easily snap itself into the gobo wheel slot. |
Gobo Plate #1 contains a magnet used by the product for positioning purposes. When replacing gobos, be sure to return gobo plate #1 to position #1 on the wheel.
9 |