Product at a
Glance
Use on Dimmer
Outdoor Use
Sound Activated
DMX
Master/Slave
Auto Programs | | |
| ||
Replaceable Fuse | | |
Circuit breaker | ||
| ||
User Serviceable | | |
Duty Cycle | |
Safety Notes | These notes include important information about the mounting, usage, and maintenance |
| of this product; read before using the product. |
|
|
| • Always connect the product to a grounded circuit to avoid the risk of electrocution. |
| • Always disconnect the product from the power source before cleaning or replacing |
| the fuse. |
| • Avoid direct eye exposure to the light source while the product is on. |
| • Make sure the power cord is not crimped or damaged. |
| • Never disconnect the product from power by pulling or tugging on the cord. |
| • If mounting the product overhead, always secure to a fastening device using a |
| safety cable. |
| • Make sure there are no flammable materials close to the product when operating. |
| • Do not touch the product’s housing when operating because it may be very hot. |
|
|
| • Always make sure that the voltage of the outlet to which you are connecting the |
| product is within the range stated on the decal or rear panel of the product. |
| • The product is for indoor use only! To prevent risk of fire or shock, do not expose |
| the product to rain or moisture. |
| • Always install the product in a location with adequate ventilation, at least 20 in (50 |
| cm) from adjacent surfaces. |
| • Be sure that no ventilation slots on the product’s housing are blocked. |
| • Never connect the product to a dimmer. |
| • Make sure to replace the fuse with another of the same type and rating. |
| • Never carry the product from the power cord or any moving part. Always use the |
| base or mounting brackets. |
| • The maximum ambient temperature (Ta) is 104° F (40° C). Do not operate the |
| product at higher temperatures. |
| • In the event of a serious operating problem, stop using the product immediately. |
| • Never try to repair the product. Repairs carried out by unskilled people can lead to |
| damage or malfunction. Contact the nearest authorized technical assistance center. |
| • This product is not intended for permanent installation. |
|
|
| • Keep this User Manual for future use. If you sell the product to another user, be |
| sure to give this document to the next owner. |
|
|
Page 4 of 15 | Minisphere™ 3.1 User Manual (Rev. 1) |