Chauvet 3.1 user manual Configuration Standalone, Sound-Active Mode Automatic Programs

Page 11

Configuration

(Standalone)

Sound-Active Mode

Automatic

Programs

Set the product in one of the standalone modes to control without a DMX controller.

1.Connect the product to a suitable power outlet.

2.Turn the product on.

Never connect a product that is operating in any standalone mode (either Static, Automatic, or Sound) to a DMX string connected to a DMX controller. Products in standalone mode may transmit DMX signals that could interfere with the DMX signals from the controller.

To enable the Sound-Active mode, do the following:

1.Press <MENU repeatedly until SNd shows on the display.

2.Press <ENTER>.

The product will only respond to low frequencies of music (bass and drums).

To enable the automatic programs, follow the instructions below:

1.Press <MENU> repeatedly until P--shows on the display.

2.Press <ENTER>.

3.Use <UP> or <DOWN> select an automatic program from P 1–P 9.

4.Press <MENU> until S--shows on the display.

5.Press <UP> or <DOWN> to adjust the speed of the automatic programs (S 1–S100).

6.Press <ENTER>.

Minisphere™ User Manual (Rev. 1)

Page 11 of 15

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Page Table of Contents Unpacking Instructions What Is IncludedSymbols Before YOU BeginProduct at a Glance Safety NotesOverview IntroductionDimensions Disconnect the product from power before replacing the fuse SetupFuse Replacement Rigging OrientationStarting Address ConfigurationOperation Control Panel OperationChannel Channel Function Value SettingDMX Channel Mode, Assignments, and Values Sound-Active Mode Automatic Programs Configuration StandaloneMaster unit Master/Slave ModeSlave units Set the DMX address to dTechnical Information Product MaintenanceTechnical Specifications General Information Returns Contact Us
Top Page Image Contents