Casablanca Fan Company 84GxxD warranty Canopy Electrical Connections, Canopy Hatch Installation

FOUR SEASONS™ III

CROSSBAR MOUNTINGHANGINGBRACKETTHE FANINSTALLATION

Step 7. To hang the fan body in the canopy, hold the fan body firmly and insert the ball into the canopy opening. Check that no wires were pinched. Rotate the fan body until the slot in the nylon ball fits into the pin opposite the canopy opening.

NOTE: The fan weight is 17 pounds.

NOTE: Independent control of the light fixture using a W-8 requires an additional power wire run from the wall switch to the fan. See Page 12 for wiring.

BALL

D1

OPTION

WIRE

SLOT PIN

CAPPED BLUE D1-OPTION WIRE ON 3-SPEED ONLY

FOR INDEPENDENT W-8 LIGHT CONTROL

CANOPY ELECTRICAL CONNECTIONS

Step 8a. Attach the fan wires to the ceiling fixture outlet box wiring by twisting the bare ends of the wires together and then securing with a wire nut. Test that the connection is secure by pulling on the wire nut. Connect in this order:

Step 8b. Pull Chain or W-4 Wiring Connections

•GREEN leads from mounting plate and fan to GROUND conductor of power source. Secure with wire nut.

•WHITE wire from fan to white NEUTRAL wire in ceiling fixture outlet box. Secure with wire nut.

•BLUE wire and BLACK power wire from fan to BLACK power wire in ceiling outlet box. Secure with wire nut.

WIRE NUT	PULL CHAIN OR
	W-4 CONNECTIONS

2 BLACK & BLUE

D1-OPTION WIRES

(WITHOUT W-8)

2 WHITE WIRES

3 GREEN WIRES

Step 8c. W-8 Wiring Connections

•GREEN leads from mounting plate and fan to GROUND conductor of power source. Secure with wire nut.

•WHITE wire from fan to white NEUTRAL wire in ceiling fixture outlet box. Secure with wire nut.

•BLACK power wire from fan to RED wire from W-8 in ceiling outlet box. Secure with wire nut.

•BLUE wire from fan to YELLOW wire from W-8 in ceiling outlet box. Secure with wire nut.

NOTE: SEE PAGE 12 FOR ADDITIONAL WIRING INFORMATION.

W-8 CONNECTIONS

BLUE & YELLOW

WIRES

BLACK & RED

WIRES

2 WHITE WIRES 3 GREEN WIRES

CANOPY HATCH INSTALLATION

Step 9. Tuck the wires into the canopy with the wire nuts pointed upwards, so that the WHITE and BLACK wires are on opposite sides of the canopy and all wires are clear of the canopy opening.

Step 10. Install canopy hatch with the last canopy screw and lock washer. To do this, tilt the fan body away from the hatch opening.

Tighten the screws firmly by hand only.

Step 11. Straighten the fan, then check to ensure that there is no movement between the canopy and ceiling or Hang- Tru ball and top support shaft.

CANOPY

HATCH

LOCK

WASHER

	TILT THE
CANOPY	FAN TO
SCREW	INSTALL
	LAST
	CANOPY
	SCREW

6