Casablanca Fan Company 6643Z Operation Power, Operation Speed Control, Operation lights

	® 3
			Operation Power
The	button is normally left in the on position. Always turn the power off

during cleaning or servicing the fan and during thunderstorms. It is also used to exit or enter additional programs.

The button must be left on to retain a previously set fan speed or light level.

Operation Speed Control

There are six individual speed settings for the fan; each speed is indicated by an audible tone of increasing pitch.

Fan Control

To select the desired fan speed:

1.With fan off, press and hold the button labeled . The fan blades will start rotating at the slowest speed, and will increase in steps.

2.Release the button when the desired speed is reached.

The fan speed is now in memory and will automatically come on at the

same speed each time the	button is used. To maintain this level
of speed, turn the fan on by pressing		less than one second. To

lower speed, turn fan off, then on by pressing and holding the button until the desired speed is reached. When the fan is on, you may

increase the speed by pressing and holding the	button until the
desired speed is reached, then release it.

ON - OFF:

Amomentary press of the FAN button

Change speed:

Press and hold

FAN button longer than one second

Operation Reversing Airflow

The direction of airflow can be changed from down- ward to upward or from upward to downward.

To reverse the airflow:
1. Make sure the	is on and blades are Turn-
ing.
2. Press the	button.

Note: A four-toned signal indicates the command was accepted by the fan. A few seconds later the fan will slow to a stop and then reverse direction.

Operation lights

To turn the lights off and on, press and release the	button for less than
one second.

1) First press/release of the button- The light will turn ON.

2) Second press/release of the button- The light will turn OFF.

To vary the light brightness at each touch level:

To vary the light brightness:

1.With lights off, press and hold the button. After one second the lights will come on at their lowest level and gradually become brighter.

NOTE: Light Operation - the light varies from “bright” to “dim” over

approximately 8 seconds. This sequence will reverse the light when it

reaches the brightest or dimmest level if you continue to hold the LIGHT button. Release the button when the desired level is reached.

2. Release the button when the desired brightness level is reached.

The brightness level is now in the fan memory and will automatically come on at the same brightness the next time the button is used.

Light Control

ON - OFF:

A momentary press of

the LIGHT button

Change bright-

ness:

Press and hold

LIGHT button

longer than one

second

18