Cal Flame Portable Spa manual Adjusting The Proper Bromine Levels, Once a Week

Page 30

28

Clear PlanWater

Start Up

1.Clean surface of spa with Cal Spas “Multi-Purpose Cleaner”.

2.Apply a protective coat of Cal Spas “Fast Sheen” to the acrylic surface.

3.Fill spa to proper water level with normal tap water. Do not use soft water.

4.Use a test strip and balance the spa water:

•Adjust total alkalinity (acceptable range is 80 to 120 ppm),

•Adjust pH if necessary (between 7.2 to 7.8).

5.Pour in 16 oz. of Cal Spas “Metal Protector” in the center of spa.

6.Test for TDS (total dissolved solids).

•The ideal range is 50 to 300 ppm.

•TDS must be less than 500 ppm to start with.

7.Test for phosphates. Phosphate level should be below 200 ppb. Remove phosphates if necessary.

8.Determine the gallon capacity of the spa. Be accurate, because this determines the amount of TRU BLU that will be added. Consult the Cal Spas Pre-delivery Guide for spa gallons.

9.Power up the spa and make sure all the spa’s pumps are set to high speed. Turn the dial on the face of the Cal Clarity Bromine Generator to OFF.

10.Sprinkle evenly over the surface of the spa one 2lb bottle of TRU BLU sodium bromide per 100

US gallons (370 liters) of water. Do not add too much!

Note: Each bottle of TRU BLU will raise TDS / conductivity amount approximately 500 ppm.

11.Allow spa to run for 15 minutes so the TRU BLU can dissolve completely before proceeding to the next step.

12.Use sodium bromide test strips (not bromine) and adjust sodium bromide level to 7.4 to 8.2 (equates to 1700 to 2500 ppm TDS level).

13.Add 2 oz of Cal Spas “Oxidizer Shock” to help burn out impurities in fill water.

14.Turn the dial on the bromine generator clockwise until the LED display reads 10.

15.This will initiate the build up of a bromine bank.

16.Set the filtration cycle to “continuous” (F-C) for the first 24 hours.

17.Put the cover on and allow the spa to heat to desired temperature.

Adjusting The Proper Bromine Levels

1.After start up, decrease the filtration cycle to F-4 and monitor the bromine level until it is within the recommended range.

2.Use bromine test strips to achieve a 3-5 ppm recommended level.

Note: It can take several days for the bromine level to stabilize because the fill water that was used sometimes contains contaminants that need to be neutralized, thereby using up the initial bromine that is generated.

3.Once the desired level has been achieved, turn the dial down until a maintenance setting is achieved. The common maintenance setting for an average bather load is 4.

When changing the setting, use bromine test strips to determine when you have reached the level you want.

Once a Week

1.Test spa water with bromine test strip.

2.Based on test strip readings:

•Adjust alkalinity if necessary.

•Adjust pH if necessary.

•Increase / decrease bromine production with dial if required.

3.Remove dirty filter from the spa and rinse off.

4.Place your clean, extra filter cartridge back into the spa.

5.Add 2 oz of Cal Spas “Oxidizer Shock” to spa. Run spa for 15 minutes

6.Vacuum debris from the bottom of your spa with the “Spa Vacuum”.

7.Replace cover.

2009 Portable Spa

www.calspas.com

LTR20091000, Rev. A

Page 29 Page 31
Image 30
Page 29 Page 31
Contents LTR20091000, Rev. a 11/24/08 Preparing for Your New Portable Spa Cleaning and Maintenance Operating Your SpaUsing the Entertainment System Appendix Clear Water PlanImportant Safety Instructions Read This FirstHyperthermia Danger Planning the Best Location Preparing for Your New Portable SpaPreparing forYour New Preparing a Good FoundationVolt Electrical Installation Gfci and Wiring RequirementsTesting the Gfci Breaker Spa Model Gfci Required Wires Required Portable SpaConfiguring the 6300 Control System Electrical Installation for 11 kW HeaterYour New Portable Spa Gfci Wiring Diagram Preparing forYour New Portable SpaGas Heater Hook up Preparing forYour New Portable Spa Filling and Powering Up Your Portable Spa Never fill your spa with soft waterOperating Your Spa OperatingYour Spa5100, 6200 and 6300 Electronic Control Operation Spa Your Spa Electronic Control OperationAuxiliary Control Operation Sounds Good System Operation InvertLocking the Panel Operating SpaYour Periodic Reminder MessagesOn display Diagnostic MessagesMessage Meaning Action Required No message DryMessage Meaning Action Required Snb SnsStby Waterfalls JetsDiverter Knobs Air VenturisAdjustable Therapy System Wireless Spa MonitorLED Perimeter Lighting Clear PlanWater Contents of this sectionClear Water Plan Key to Clear WaterBalancing the Total Alkalinity Testing and Adjusting Spa WaterClear Water Plan Balancing the pHSanitation Using Chlorine as a SanitizerUsing Bromine as a Sanitizer Adding Sanitizer Tablets to the Chemical ChamberChemical Safety Shocking the WaterFilter Cleaning Bather LoadStarting the Spa with Fresh Water Water PlanMaintenance Schedule Start Up Cal Zone Quest OzonatorCal Clarity Bromine Generator Day One MondayAdjusting The Proper Bromine Levels Once a WeekTroubleshooting Water Clarity Problems ClearCleaning and Maintenance Removing and Reseating the PillowsSpa Cover Cleaning and Replacing the Filter Draining Your Portable SpaCleaning the Cover, Shell and Pillows Use of Vinyl and Leather CleanerWinterizing Cold Climate Draining Prior to Spa Start-Up and Refilling All-Purpose Cleaner Spa Finish cleaningPeriodic Maintenance Fast Sheen Spa Finish Protecting WaxListening to the Radio Using the Entertainment SystemTheUsing SystemEntertainment Inserting and Ejecting a CD or DVDRaising and Lowering the 20 TV Using the Entertainment SystemPlaying a CD Playing a MovieProgramming the Universal Remote Control Using the iPod Docking StationDevice Manufacturer Code Type Replacement Parts AppendixValves PillowsHand Rails DrainsCover Lifts WaterfallsLights Replacement Cabinet PanelsOzone Cartridges LED LightsCovers Avalon SeriesClassic Series Fitness Series CN-48/CN-63 93 xFamily II Series Galaxy SeriesVictory Xtreme Series VX901 72 xKeeping Fit with your Spa Ultimate Fitness Series Exercise ProgramConnecting the Exercise Equipment Warranty Portable SpasCustomer Service Proration of WarrantyWarranty Limitations and Exclusions DisclaimersCal Spas Chemicals LMS Customer Service Department Locating the product serial number

Portable Spa specifications

The Cal Flame Portable Spa is a remarkable addition to outdoor relaxation, combining innovation and comfort in a sleek design. This portable hot tub provides users with the luxury of a spa experience right in their own backyard or on the go. One of the standout features of the Cal Flame Portable Spa is its easy setup and compact design, allowing for straightforward installation and mobility. Made with durable materials, these spas are built to withstand various weather conditions, ensuring longevity and reliability.

One of the key characteristics of the Cal Flame Portable Spa is its seating capacity. Designed to accommodate multiple users, many models can comfortably fit between four to six people, making it perfect for family gatherings or social events. The ergonomic seats provide optimal support, allowing users to unwind and relax in comfort, enhancing the overall experience.

Heating technology is another highlight of this portable spa. Equipped with a powerful heating system, users can easily adjust the water temperature to their liking, offering a customizable experience. The energy-efficient heater ensures that your spa is warm and ready for use while also keeping utility costs low.

The hydromassage jets in the Cal Flame Portable Spa play a pivotal role in creating a soothing atmosphere. Strategically positioned, these jets deliver a targeted massage experience, relieving stress and tension in muscles. Users can also control the intensity and direction of the jets, tailoring their spa experience to individual preferences.

In addition to comfort and relaxation, safety features are paramount in the Cal Flame Portable Spa. It comes with a secure cover, reducing heat loss and preventing unauthorized access when not in use. The spa's design also incorporates slip-resistant surfaces to minimize the risk of accidents.

Lastly, the aesthetic appeal of the Cal Flame Portable Spa cannot be overlooked. With a variety of colors and finishes available, users can choose a design that complements their outdoor décor. The combination of function and style makes the Cal Flame Portable Spa an attractive feature in any outdoor space, promoting relaxation and leisure for years to come. Overall, this portable spa delivers an exceptional hydrotherapy experience, perfect for enhancing your outdoor lifestyle.
Top Page Image Contents