Buhler FK369 manual Spindle Replacement

Page 21

Heavy Duty Finishing Mower

SPINDLE REPLACEMENT

OUTER SPINDLES: remove the belt guard on the side required (#7 & #8). Loosen the belts by first loosening the bolts holding the gearbox base plate (#2). Turn the 5/8” hex nut (#3) on the threaded rod on the base plate until there is enough slack in the belt to slip it off the spindle pulley. Remove the snap ring from the spindle shaft and pull off the pulley. Remove the blade from the spindle. The mower will have to be raised off the ground. Take off the four bolts holding on the spindle (#14). After replacing the spindle, be sure that the bolt holding the blade is tightened to 180 ft-lbs. Use a torque wrench. Re-tighten the belts so the center of the belt span will deflect about ½” with nominal pressure. Do not forget to tighten the bolts on the gearbox mounting plate.

CENTER SPINDLE: The procedure is the same as for the outer spindles as described above except for the following differences. Both belt guards (#7 & #8) must be removed. After slacking off the belt as described remove the gearbox mounting plate (#6) in one piece with the gearbox and large pulley. Remove the double pulley and replace the spindle. When you replace the belts make sure they are lined up as shown in the drawing. The upper grooves in the double pulleys go around the higher of the single pulleys. The lower grooves of the double pulley line up with the lower single pulley.

Drawing on next page.

17

Image 21

Contents Page Page Table of Contents Description Shipping KIT and Bundle Numbers Parts DrawingsWarranty Labor Warranty ClaimsGovernment Legislation Important FactsIntroduction Safety General Safety Instructions START-UP SafetyOperation Safety Service and Maintenance Safety Transport SafetyStorage Safety Safety SignsHeavy Duty Finishing Mower Safety Signs Safety Signs cont’d Hitch Assembly Instructions Chain KIT AssemblyQuick Hitch KIT Instructions START-UP Operating Instructions Connecting to TractorField Operation Disconnecting from TractorTheory of Operation Maintenance Heavy Duty Finishing Mower PTO Shafts PTO Shaft Mower Deck Wheel Bearings Item PART# Description Mower Deck Wheel BearingsMower Spindle Lubrication Mower Gearbox LubricationSpindle Replacement Heavy Duty Maintenance Spindle Replacement Spindle Replacement Item PART# Blade Replacement Blade Replacment Item PART# Every 8 Hours of USE Date Service NotesEvery 20 Hours of USE Every 40 Hours of USEChecking Bolt Torque ’, 6’ & 7’ Heavy Duty Rear Discharge Finishing Mower 7 Heavy Duty Rear Discharge Finishing Mower When Ordering PartsPage Page Heavy Duty Finishing Mower Gearbox Item # Description Heavy Duty Finishing Mower Gearbox Parts ListHeavy Duty Finishing Mower Spindle Assembly Finishing Mower Spindle Parts List 4, 5 & 6 Side and Rear Heavy Duty Rear Discharge Finishing Mower PTO Shaft Item # Description Heavy Duty Finishing Mower Heavy Duty Rear Discharge Chain KIT Quick Hitch KIT Blade Height Adjustment Item PART# Description Blade Height AdjustmentMower Deck Belt Adjustment Mower Deck Belt Adjustment Quantity Bundle no Description Heavy Duty Finishing MowerOptional Bundle Numbers Page Page Page Buhler Manufacturing