Buhler FK369 manual Blade Height Adjustment Item PART# Description

Page 41

Heavy Duty Finishing Mower

BLADE HEIGHT ADJUSTMENT

The mowers must be raised off the ground far enough to pull the wheel yoke (#5) out of the welded sleeves at the ends of the axles (#1). Be sure the tractor is turned off. Pull out the clip (#4) and remove the wheel yoke. There are ½” and 1” spacers to adjust the cutting height. The cutting height is 1 ¾” with no spacers under the sleeve at the end of the axles. This can be adjusted using the spacers by ½” increments up to 4 ¾”. Check to see that the spacers are set at the same height on all the wheel yokes.

BLADE HEIGHT ADJUSTMENT

ITEM PART# DESCRIPTION

1908942 67 1/2'' Axle Beam Weldment (5')

908944 69 1/2'' Axle Beam Weldment (6')

908946 71 1/2'' Right Axle Beam Weldment (7')

2902504 1/2'' Lg x 1 5/8'' OD Bushing (pl)

3902503 1'' Lg x 1 5/8'' OD Bushing (pl)

4966729 3/16'' Linch Pin (pl)

5

902422

Wheel Yoke

37

Image 41

Contents Page Page Table of Contents Description Shipping KIT and Bundle Numbers Parts DrawingsWarranty Labor Warranty ClaimsGovernment Legislation Important FactsIntroduction Safety Operation Safety General Safety InstructionsSTART-UP Safety Service and Maintenance Safety Transport SafetyStorage Safety Safety SignsHeavy Duty Finishing Mower Safety Signs Safety Signs cont’d Quick Hitch KIT Instructions Hitch Assembly InstructionsChain KIT Assembly START-UP Operating Instructions Connecting to TractorField Operation Disconnecting from TractorTheory of Operation Maintenance Heavy Duty Finishing Mower PTO Shafts PTO Shaft Mower Deck Wheel Bearings Item PART# Description Mower Deck Wheel BearingsMower Spindle Lubrication Mower Gearbox LubricationSpindle Replacement Heavy Duty Maintenance Spindle Replacement Spindle Replacement Item PART# Blade Replacement Blade Replacment Item PART# Every 8 Hours of USE Date Service NotesEvery 20 Hours of USE Every 40 Hours of USEChecking Bolt Torque ’, 6’ & 7’ Heavy Duty Rear Discharge Finishing Mower 7 Heavy Duty Rear Discharge Finishing Mower When Ordering PartsPage Page Heavy Duty Finishing Mower Gearbox Item # Description Heavy Duty Finishing Mower Gearbox Parts ListHeavy Duty Finishing Mower Spindle Assembly Finishing Mower Spindle Parts List 4, 5 & 6 Side and Rear Heavy Duty Rear Discharge Finishing Mower PTO Shaft Item # Description Heavy Duty Finishing Mower Heavy Duty Rear Discharge Chain KIT Quick Hitch KIT Blade Height Adjustment Item PART# Description Blade Height AdjustmentMower Deck Belt Adjustment Mower Deck Belt Adjustment Optional Bundle Numbers Quantity Bundle no DescriptionHeavy Duty Finishing Mower Page Page Page Buhler Manufacturing