Bush Hog 2347 QT manual Optional Hydraulic Valve Stand Assembly Figure

Page 25

Figure 5-5 Valve Stand Assembly

Optional

Mounting Bracket

			Dual Handle Valve Single Handle Valve


					Operational
	Shield				Operational
	Shield				Decal

1/2 x 1-1/2”	3/8 x 1-1/4”

5/8 x 6-1/2”

5/16 x 3”

Mounting Bracket

1/2 X 3”

1/2 X 1-1/2”

5/8 X 6-1/2”

Mounting Plate

5-2 OPTIONAL HYDRAULIC VALVE STAND ASSEMBLY (Figure 5-5)

A. Attach mounting plate to loader frame using two 5/8 x 6-1/2” bolts, flatwashers, lockwashers and nuts. Note that this plate may be rotated 180° to allow three different mounting tube heights.

B. Attach mounting bracket to plate using two 1/2 x 1-1/2” bolts, lockwashers and nuts.

(2)

5/16 X 2-1/2”

5/16 X 3”

Valve

Plate

5/16 X 1”

Tube

Optional Brace

C. Attach mounting tube to bracket using 1/2 x 3” bolts, lockwashers and nuts. The slotted hole also requires a flatwasher, as shown.

D. Attach valve plate to tube using U-bolts, lock- washers and nuts. Note: Mounting tube may be too long for tractor being mounted and should be cut to desired length.

23

Image 25

Contents Bush HOG Congratulations Retail CUSTOMER’S Responsibility Under the Bush HOG Warranty Table of ContentsDisclaimer of Implied Warranties & Consequential Damages This Limited Warranty Shall not ApplyDealer Preparation Check List Tractor Important Safety PrecautionsLoader Operating the Loader Safety PrecautionsEmployee Tractor Operating Instructions EMPLOYERS, Employees and OperationsIntroduction Section Introduction and DescriptionTechnical Specifications Preparing Tractor Section Loader Mounting and DismountingMounting Loader Tighten Nut To 85 ft./lbs Dismounting Loader Section Operating Instructions General SafetyOperation Lifting the Load Filling the BucketDumping the Bucket Carrying the LoadLowering the Bucket Not this Do this Dump Lower Leverrollback ControlsraiseFloat Operating with Float ControlFloat Surface Material Loading from a Bank 3RD CUT , 4TH CUT, ETC Peeling and ScrapingLoading LOW Trucks or Spreaders from a Pile BackfillingSoil Pile Bale Spear OperationHandling Large Heavy Objects Quick Hitch Operation Fork Lift OperationTransporting Maintenance Check List Section MaintenanceHydraulic System Pressure Requirements Before Each USETroubleshooting Procedures Problem Possible Cause Remedy TroubleshootingMainframe Assembly AssemblySection Parking Stands Installed Optional Hydraulic Valve Stand Assembly Figure Hose Color Codes Optional Hydraulic Valve Plumbing InstructionsBasic Power Beyond Plumbing Instructions Bale Spear Option Fork Lift OptionTine Teeth Safety Decals American Torque Specifications