Bush Hog manual Dealer Preparation Check List, 305/306 Series Rotary Cutters

Page 5

DEALER PREPARATION CHECK LIST

305/306 SERIES ROTARY CUTTERS

BEFORE DELIVERING MACHINE — The following check list should be completed.

Use the Operator’s Manual as a guide.

❒1. Assembly completed.

❒2. Gearbox filled with oil.

❒3. All fittings lubricated.

❒4. All shields in place and in good condition.

❒5. All fasteners torqued to specifications given in Torque Chart.

❒6. Slip clutches have been checked for proper operation.

❒7. All decals in place and readable. (See decal page.)

❒8. Overall condition good (i.e. paint, welds)

❒9. Operators manual has been delivered to owner and he has been instructed on the safe and proper use of the cutter.

❒10. Purchaser or dealer elects to delete deflectors. (front chains)

Explanation:

WARNING

For Non-Agricultural use, OSHA, ASAE, SAE and ANSI standards require the use of Chain Guards or other protective guards at all times. Bush Hog strongly recommends the use of such guards for Agricultural uses as well, to reduce the risk of property damage, serious bodily injury or even death from objects thrown out by or from con- tact with the cutting blades.

Dealer’s

Signature

Purchaser’s

Signature

THIS CHECKLIST TO REMAIN IN OWNER’S MANUAL

It is the responsibility of the dealer to complete the procedures listed above before delivery of this implement to the customer.

3

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Bush HOG Congratulations Retail CUSTOMER’S Responsibility Under the Bush HOG Warranty Table of ContentsDealer if parts or service are required This Limited Warranty Shall not ApplyDisclaimer of Implied Warranties & Consequential Damages Ranties, implied or expressed305/306 Series Rotary Cutters Dealer Preparation Check ListImportant Safety Precautions Employee Tractor Operating Instructions EMPLOYERS, Employees and OperationsThis Act Seeks Osha RegulationsIntroduction Section Introduction and DescriptionDescription SeriesTo Match Tractor PTO Shaft Section Preparation for USEAttaching to Tractor Repeat steps I and J to other driveline section Contact authorized Bush Hog dealer Minimum OverlapAdjusting for Work General SafetyCutting Height Adjustment SectionArea Maintenance Check ListTransporting Slip Clutch Operational Check Blade ReplacementIs in good condition Replace blade holder and tighten the lowerGearbox Maintenance Slip Clutch AdjustmentProblem Probable Cause TroubleshootingYoke PRE-ASSEMBLY Safety PrecautionsSetting Tailwheel AssemblyFollow the Proper Adjustment PRO Cedure Heavy Duty 3-POINT Hitch50029419 78608 78786 Safety Decals50029418 SAE Grade Dashes Torque SpecificationsSAE Grade No Dashes Bush HOG, L.L.C
Top Page Image Contents