Bush Hog RFM 60 manual Rfm

Page 17

E. Fasten mast supports and upper flex link to mast halves using 1/2 x 5” capscrew, pivot tube and locknut.

F. Place two long spacers on the caster stems and insert into caster arms. Place two long spacers and two short spacers on the caster stem above the caster arms. This arrangement will give a cutting height of approximately 3-1/2 inches. Secure with

lynch pin retainers. With weight of cutter resting on all four wheels, ensure that cutter is level. Tighten all bolts on mounting brackets.

G. Fill gearbox with EP80W-90 gear oil until oil level is at check plug on side of gearbox housing. (Capacity is 1 quart) Replace solid fill plug with breather plug supplied in operator’s manual package.

RFM 60

Gearbox Oil Level

Check Plug

15

Image 17

Contents Bush HOG Congratulations Operator’sRFM 60Manual Table of ContentsDisclaimer of Implied Warranties & Consequential Damages This Limited Warranty Shall not ApplyDealer Preparation Check List Your Safety is Involved Safety Alert SymbolImportant Safety Precautions Rops EMPLOYERS, Employees and OperationsEmployee Tractor Operating Instructions Description Section Introduction and DescriptionIntroduction Attaching to Tractor Section Preparation for USEFlex-Link Tractor Top Link Lower Lift Arm Section Operating Instructions General SafetyCutting Height Adjustment Maintenance Check List Section MaintenanceBefore Each USE After Each USEBelt Replacement Belt AdjustmentRFM 60 Belt Diagram FrontTroubleshooting Blade ReplacementProblem Probable Cause Remedy Wear Heavy Work Gloves to PROSection Dealer AssemblyRFM Safety Decals SAE Grade Dashes Torque SpecificationsGriffin Avenue Selma, AL Telephone 334