4Because this snow thrower attachment is compatible with several model lawn tractors and garden tractors with either an electric PTO or a manual PTO, four upper drive belts are included. If you have had any problems locating the proper upper belts for installation in the previous steps, use the table below for quick reference.
Assembly
Model Series
All 800 series
Refer to the table below to determine which upper drive belt is applicable to your tractor;
Upper Drive Belt Reference Chart
Deck Size | Electric PTO Manual PTO |
Click Pins
Belt Keeper
Cub Cadet 11C & 13C
WARNING
Before installing attachment, place tractor on a firm and level surface. Place the PTO in
the disengaged
(OFF) position, set the parking brake, shut engine off and remove key to prevent unintended starting.
N/A | ||
(Garden Tractor) |
|
|
(Lawn Tractor) |
|
|
|
| |
|
| |
N/A | ||
|
|
NOTE: If you engage your tractor’s cutting deck by using your left hand to pivot a lever forward, your tractor has a Manual PTO. If you engage your tractor’s cutting deck by pulling outward on a small knob located on the tractor’s dash, your tractor has an Electric PTO.
Mounting The
Undercarriage Assembly
(All 600-649 & 800 Model Series Tractors)
1.Remove and retain the four hairpin clips from the weld pins found the top side of the undercarriage assembly, and also the 4 clevis pins with hairpin clips. Retain this hardware for later installation. See Figure 12.
IMPORTANT: Make certain the correct upper drive belt is installed on the undercarriage assembly prior to proceeding with mounting the undercarriage. Make sure that the upper
certain that the flat side of the belt is facing outward.
2.Position the undercarriage assembly beneath the tractor. For manual PTO units, hook up the PTO cable as described earlier in this section.
3.Move the tractor’s deck lift lever into the lowest notch on the fender allowing the lift arms to drop. See Figure 13.
Clevis Pins
Undercarriage Assembly
Figure 12
Deck Lift
Lever
Lift Arm
Figure 13
12
