Lift Arm
Clevis Pin
Figure 14
Figure 15
Figure 16
Spring Attached to Idler Pulley
4.Align the holes in the rear of the lift arms with the holes in the rear of the undercarriage and insert the clevis pins removed in step 1. Fasten with the hairpin clips. See Figure 14.
5.Move the tractor’s deck lift lever into the top notch on the right fender allowing the lift arms and the rear of the undercarriage assembly to rise.
6.Insert the weldpins found on the top side of the rear portion of the undercarriage assembly up through the aligning holes found along the tractor’s frame rail. See Figure 15.
7.Fasten with the hairpin clips removed in step 1.
8.Repeat the previous two steps on the front portion of the undercarriage assembly.
9.Connect the extension spring to the tractor’s frame rail in the hole provided. See Figure 16.
NOTE: The other end of the spring is attached to the idler pulley. For an example of where this spring should attach, see Figure 14.
NOTE: Refer to the Routing the Upper Drive Belt section of this manual (Page 18) for proper upper drive belt installation instructions. Routing The Lower Drive Belt instructions can also be found in that section.
4
Assembly
Model Series
600-649 &
All 800 series
Cub Cadet 11C & 13C
WARNING
Before installing attachment, place tractor on a firm and level surface. Place the PTO in
the disengaged
(OFF) position, set the parking brake, shut engine off and remove key to prevent unintended starting.
13
