Lube Spiral
and Chute Base
Joint Block
Figure 36
Shear Pin | Spacers | Bearing |
|
|
Figure 37
Maintenance
WARNING: Before lubricating, repairing, or inspecting, place tractor on a firm and level surface. Place the PTO in the disengaged (OFF) position, set the parking brake, shut engine off, and remove key to prevent unintended starting.
Lubrication of
Chute Directional Control
The spiral on the end of the lower chute crank, the base of the discharge chute itself and the joint blocks which connect the lower and upper chute cranks should be lubed with
Auger Shaft
1.At least once a season, remove the shear bolts on the auger shaft. Oil or spray lubricant inside and on the plastic bearings on the shaft and near the holes where the shear bolts were removed before reattaching them. See Figure 37.
12
Maintenance
All Models
WARNING
Before lubricating,
repairing, or
inspecting, place tractor on a firm and level surface. Place the PTO in the disengaged (OFF) position, set the parking brake, shut engine off, and remove key to prevent unintended starting.
23
