6
Assembling
Controls
All Models
NOTE:
All references to left or right side of the
Upper Chute
Crank Rod
Joint Block
Lower Chute
Crank Rod
B
A
Chute Directional
Control Assembly
Figure 24
snow thrower is
from the operating
position only.
Attaching the Chute Directional Control
1.Secure the upper chute crank rod to the joint block
(A)on the lower chute crank rod with the cotter pin
(B)provided. See Figure 24.
2.Attach the chute directional control assembly to the upper lift link on the left side of the auger housing assembly with two hex screws as illustrated in Figure 25. Secure with two flange nuts.
3.Fasten the chute tilt cables to the chute directional control with two of the cable ties provided. Pull the cable ties until they’re snug and trim off excess.
Upper Lift Link
Attaching The
Lift Handle
1.Attach the lift handle to the lift bracket on the right side of the auger housing assembly with the two hex screws and two flange nuts provided. See Figure 26.
2.Fasten the lift cable to the lift handle with two of the cable ties provided. Pull the cable ties until they’re snug and trim off any excess.
Lift Handle
Chute Directional
Control Assembly
Figure 25
Auger Housing Assembly
Figure 26
Attaching the Reflectors
Peel off the backing from each of the reflectors to expose the adhesive surface. Adhere the reflectors to the rear of the tractor’s fender (one on the left and one on the right) so that the reflectors simulate taillights.
16
