Brother CS 8060 manual Adjusting the Stitch Width and Length, Adjusting the stitch width

Adjusting the Stitch Width and Length

The zigzag width (pattern width) and stitch length of utility stitches can be adjusted. Normally, when a stitch is selected, the appropriate width and length are automatically selected. For details on the range of values within which the width and length can be set, refer to “Stitch Settings” (page 96).

CONTENTS

Adjusting the stitch width

1Press the stitch width adjustment button in the operation panel.

X The stitch width adjustment indicator lights up.

2Slideleft ortheright.stitch width adjustment slider to the Sliding the stitch width adjustment slider to the right makes the stitch width wider; sliding the slider to the left makes the stitch width narrower.

1
2	3

1Stitch width adjustment indicator

2 Stitch width adjustment button

3 Stitch width adjustment slider

■Changing the needle position

With the straight stitch (left needle position) and the triple stretch stitch, the needle position can be adjusted. Sliding the stitch width adjustment slider to the right moves the needle to the right; sliding the slider to the left moves the needle to the left.

CAUTION

●After adjusting the stitch width, slowly turn the balance wheel toward you and check that the needle does not touch the presser foot. If the needle hits the presser foot, the needle may bend or break.

GETTING READY SEWING BASICS UTILITY STITCHES APPENDIX

•To automatically select the stitch width most appropriate for the selected stitch, press the stitch width adjustment button again.

INDEX

Adjusting the Thread Tension/Adjusting the Stitch Width and Length 51