Brother CS 8060 manual Eyelet Stitching, Attach monogramming foot N

Eyelet Stitching

Eyelets, such as those on belts, can be sewn. Three sizes of eyelets are possible: 7 mm, 6 mm and 5 mm (1/4, 15/64 and 3/16 inch).

			Stitch Width		Stitch Length		Presser
Stitch Name	Pattern	Application	[mm (inch.)]		[mm (inch.)]
							Foot
			Auto	Manual	Auto	Manual
				7.0, 6.0 or
Eyelet stitch		Sewing eyelets, for example,	7.0	5.0 (1/4,	–	–	N
		on belts	(1/4)	15/64 or
				3/16)

CONTENTS GETTING

1Attach monogramming foot “N”.

•For details, refer to “Replacing the presser foot” (page 35).

2Select stitch .

•For details, refer to “Selecting stitching” (page 58).

3Adjust the stitch width to select the desired eyelet size.

7 mm 6 mm 5 mm (1/4 inch)(15/64 inch) (3/16 inch)

•For details, refer to “Adjusting the Stitch Width and Length” (page 51).

4Lower the needle into the fabric at the beginning of the stitching, and then lower the presser foot lever.

5Start sewing.

X Once sewing is completed, the machine automatically sews reinforcement stitches, then stops.

6Use the eyelet punch to cut a hole in the center of the eyelet.

•When using the eyelet punch, place thick paper or some other protective sheet under the fabric before punching the hole in the fabric.

Memo

●If thin thread is used, the stitching may be coarse. If this occurs, sew the eyelet twice before remove the fabric, one on top of the other.

READY SEWING BASICS UTILITY STITCHES APPENDIX

INDEX

Eyelet Stitching 87