Briggs & Stratton LT-200 manual Check Fluid Levels, Check Transmission Oil Level

Page 5

LT-200 Series

Check Fluid

Levels

Check Transmission Oil Level

The K46 transmission is a sealed unit that is shipped with the correct oil level. However if a transmission’s oil level is suspect it can be checked. See Transmission Maintenance.

Fill & Check Engine Oil

Service Interval: Before each use, and every 8 hours.

1.Turn the engine off, and set the parking brake to PARK.

2.Clean the area around the dip stick (C, Figure 3).

3.Remove the dip stick (C) and clean it with a paper towel.

4.Insert the dip stick (C) back into the engine and thread the cap back onto the tube.

5.Remove the dip stick and read the oil level. The oil level should be between the “FULL” and “ADD” marks

(D). If not, add oil according to the oil recommendations chart (Figure 39 or 40).

D

B

 

C

 

A

 

Figure 3. Briggs & Stratton two cylinder Models

A.Oil Drain Valve

B.Oil Filter

C.Dip Stick

D.Checking Oil Level

3/2007

5

TP 300-4517-00-RG-N

Image 5
Contents Setup Adjustment Instructions Safety Rules Quick Setup List Charge Battery Battery Charging InstallationInstall Battery Battery Safety RulesFill & Check Engine Oil Check Fluid LevelsCheck Transmission Oil Level Safety Interlock System Tests Perform Safety ChecksReduce & Check Tire Pressures Torque Mower BladesBurnishing the Electric PTO Clutch SizeOil LubricationMower Lubrication Points HourmeterRemoving the Mower Deck Mower Deck Removal InstallationInstalling the Mower Deck Leveling The Mower Side-to-Side Lift Rod Locknut Leveling The MowerGauge Wheels Seat AdjustmentSeat Slide Adjustment Feeler Gauge Position Electric PTO Clutch AdjustmentBelts Over Pulleys Mower Belt Replacement