RETURN-TO-NEUTRAL
ADJUSTMENT
To determine if it is necessary to adjust the neutral return, perform the following steps.
1.Disengage the PTO, engage the parking brake and turn off the engine.
2.Move the ground speed control levers into the operating position, pull levers rearward and release.
Troubleshooting, Adjustment & Service
| 3.25” | E |
|
D |
|
| |
(8,23cm) |
|
| |
C | F | A | B |
3.Move the ground speed control levers out towards the neutral position. If the levers do not align with the notches in the neutral lock plate, it is necessary to adjust the neutral return rod (B, Figure 29).
WARNING
To avoid serious injury, perform adjustments only with engine stopped, key removed and tractor on level ground.
Figure 29. Neutral Return Spring Adjustment
A.Rear Set Collar
B.Neutral Return Rod
C.Neutral Return Spring
D.Front Set Collar
E.Neutral Return Bushing
F.Spring Stop Plate
Adjustment
1.Lock the ground speed control lever in the neutral position.
2.Measure the length of the neutral return spring (C, Figure 29) it should be set at 3.25” (8,23cm). If the spring does not measure 3.25” (8,23cm) loosen the front set collar (D) and the rear set collar (A), then move the front set collar forward or back on the neutral return rod (B) until the spring length equals 3.25” (8,23cm). Retighten the front set collar.
3.Make sure that the neutral return bushing (E) is seated correctly in the spring stop plate (F).
4.Position the rear set collar so that it sets tightly against neutral return bushing and tighten.
5.Pull the ground speed control lever rearward and release to check position again. Adjust as necessary to align the ground speed control levers with the notches in the neutral lock plate.
It is important to note that after every adjustment of the neutral return rod, the lever must be pulled rearward and released to properly check the neutral position.
Troubleshooting
35