Magnavox 27MS3404R owner manual Basic Cable BOX/DECODER Connection

If your cable signal uses a cable box or decoder, follow the easy steps below to com-

plete the connection.

Cable Box Connection (RF Input/Output Only):

Cable Signal

Jack Panel Back of Cable Box

In/Outputs):

This connection will NOT supply Stereo sound to the TV. The sound from the cable box will be mono.

1 Connect the open end of the round Cable Company supplied cable to the cable signal IN(put) plug on the back of the Cable Box.

IN from the 1 2

Cable

Company

2 Using a separate round coaxial cable, connect one end to the OUT(put) (TO TV) plug on the back of the Cable Box.

3 Connect the other end of the round coaxial cable to the 75Ω input on the back of the television. Screw it down finger tight.

NOTE: Be sure to set the OUTPUT CHAN- NEL SWITCH on the back of the cable box to CH 3 or 4, then tune the TV to the corre- sponding channel. Once tuned, change chan- nels at the cable box, not the television.

Jack Panel Back of TV

Cable Box Connection (with Audio/Video Outputs):

Cable Signal IN from the Cable Company

Cable Box (w/Audio/Video Outputs):

This connection will supply Stereo sound to the TV.

Cable Box with

Audio/Video Outputs

24

4 Connect the open end of the round Cable Company supplied cable to the cable signal IN(put) plug on the back of the Cable Box.

5 Using a RCA type Video Cable, con- nect one end of the cable to the Video (or ANT, your cable box may be labeled differently) Out jack on the cable box and the other end to the AV1 Video Input on the TV.

6 Using a RCA type Audio Left and Right Cable, connect one end to the left and right Audio Out L & R jacks on the cable box. Connect the other end to the AV1 Audio L & R Input jacks on the TV.

NOTE: Use the Channel + or – buttons on the TV remote control to tune to the AV1 channel for the cable box signal. Once tuned, change channels at the cable box, not the tele- vision.

Jack Panel Back of TV