Billy Goat GZ451S, GZ401H owner manual Packing Checklist, Assembly

GZ Owner’s Manual

PACKING CHECKLIST

Your Billy Goat is shipped from the factory in one carton, completely assembled except for the upper handle assembly, lower handles, handle brace, brush lift rod, and brush.

READ all safety instructions before assembling unit. TAKE CAUTION when removing the unit from the box.

All required assembly can be done using two 1/2" combination wrenches.

1. Install the lower handles one on each side of the unit using bolt (Item 45), washer (Item 54) and nut (Item 52). There are two bolts per lower handle section. NOTE: The lower handle has a left and right hand section. Be sure when installing that each section will point to the outside of the unit when hardware is secured.

2.Install upper handle assembly by aligning the holes in the upper handle with the holes in the lower handle stubs that are preassembled on the machine. Secure the handles together using bolt (Item 46), washer (Item 54), and nut (Item 52) on the operator’s right hand side. Secure using bolt (Item 64), washer (Item 54), and nut (Item 52) on the operator’s left hand side. Use the same hardware to secure the flat end of the handle brace (Item 42) to the left side of the handle.

3. Secure the bent end of the handle brace (Item 42) to the face of the engine using bolt (Item 47)

4. Install the Brush Lift Rod (Item 38) by placing one end through the hole in the lift control arm mounted on the upper handle and securing it with a washer (Item 54) and pin (Item 60). Place the other end thought the brush pivot arm and secure in the same way. NOTE: The pin and washer come pre-installed in the ends of the rod (Item 38). Remove and re-use them for final assembly.

5. Install Brush (Item 6) by removing the Brush Guard (Item 27) and removing the brush mounting Nut (Item 15) and one Washer (Item 16). Slide the brush on the shaft and reinstall the washer, nut, and brush guard.