9GENERAL SAFETY
For your safety and the safety of others, these directions should be followed:
Do not operate this machine without first reading owner's manual and engine manufacturer's manual.
Use of Ear Protection is recommended while operating this machine.
Use of Eye and Breathing protection is recom- mended when using this machine, especially in dry
and dusty conditions. Optional bag cover directs dust toward ground, away from the operator.
·DO NOT place hands or feet inside nozzle intake opening, near debris outlet or near any moving parts.
·DO NOT start engine without debris bag and quick discon- nect connected firmly in place to exhaust outlet.
·DO NOT start or operate machine with debris bag zipper open.
·DO NOT operate during excessive vibration.
·DO NOT remove bag until engine has been turned off and has come to a complete stop.
·DO NOT remove hose kit cap on nozzle until engine has been turned off and has come to a complete stop.
·DO NOT operate machine with hose cap, bag or hose removed. ·DO NOT use this machine for vacuuming exclusively sand, dust, fine dirt, rock, glass, string like material, grain, rags, cans, metal, bark or water.
·DO NOT operate this machine on slopes greater than 20%. ·DO NOT pick up any hot or burning debris, or any toxic or explosive material.
·DO NOT allow children to operate this equipment.
| 3 |
GENERAL SAFETY | & ASSEMBLY |
10ASSEMBLY
Read all safety and operating instructions before assembling or starting this unit.
PUT OIL IN ENGINE BEFORE STARTING.
Your Billy Goat is shipped from the factory in one carton, completely assembled except for the debris bag, upper handle, bag quick disconnect, tamper and bag support assembly.
1.ASSEMBLE upper handle securely to lower handle stubs using handle screws (item 8), knob wing
2.CONNECT bag support assembly (item 78), to rear axle (item 33), of unit and to both sides of upper handle using clips on strap (item 80).
3.UNFOLD the debris bag (item 1), and fasten bag neck to bag quick disconnect (item 83). Attach firmly to housing exhaust (item 52), see fig. 2.
4.ATTACH upper bag hanger straps to loops (item 11),
5.ATTACH throttle assy. (item 2), to handle, using cable clamps (item 9).
6.INSTALL tamper in chipper hopper (see page 7).
7.CONNECT spark plug wire
11PACKING CHECKLIST
9
74 73
Attach upper handle using wingnuts, carriage bolts and lock nuts already
These items should be included in your carton. If any of these parts are missing, contact your dealer.
80
8
Check
Debris Bag 900805
Check
Handle Assy. 890204
Check
Bag Support
Assembly
Check 900647
Connector
Quick
assembled to handle stubs.
QUICK DISCONNECT
Check
Disconnect
890176 Tamper
890229
Fig. 2
Part No. 890207
Parts Bag &
Literature Assy
Engine
Manual
Denotes parts found in Parts Bag Assembly (shown on page 4).
Page 3 of 12
Check
Parts Bag &
Literature Assy
890206
Check
Briggs & Stratton
P/N 272262 English
Form No. F021795E