STORAGE
CAUTION: AVOID INJURY. Read and understand the entire Safety section before proceeding.
IMPORTANT: NEVER spray unit with high- pressure water or store unit outdoors. Store mower in a cool, dry, protected location.
Cleaning
Allow unit to cool. Clean unit thoroughly with mild soap and low pressure water. Brush off dirt and debris from all surfaces. Touch up all scratched surfaces to prevent rust. Matching
Inspection
Inspect mower and repair or replace worn or damaged parts to avoid delays when beginning use again.
Regularly check all hardware and keep fasteners tight. Know unit is in safe working condition.
Engine
Refer to engine manufacturer’s recommendations for storage.
Fuel System
Gasoline left in the fuel system for extended periods without a stabilizer will deteriorate, resulting in gum deposits in the system. These deposits can damage the carburetor and the fuel hoses, filter and tank. Prevent deposits from forming in the fuel system during storage by adding a quality fuel stabilizer to the fuel. Follow the recommended mix ratio found on the fuel stabilizer container.
To treat the fuel system for storage:
1.Add fuel stabilizer according to manufacturer’s instructions.
2.Run engine for at least 10 minutes after adding stabilizer to allow it to reach the carburetor.
NEVER store the engine with fuel in the fuel tank inside of a building with potential sources of ignition.
Grass Bag
Wash out grass bag and allow to dry before storage. Grass bag may be stored in position on mower.
TROUBLESHOOTING
PROBLEM | PROBABLE CAUSE | CORRECTION | ||
|
|
|
| |
Engine will not | 1. Fuel tank empty or low. | 1. | Check fuel level. Fill tank if | |
start | 2. | Spark plug wire loose or off. | 2. | necessary. |
| Check connection. | |||
| 3. | Engine/Blade control cable | 3. | Check cable. Adjust, repair |
|
| detached, broken, or not |
| or replace as necessary. |
|
| adjusted properly. |
|
|
|
|
|
| |
Engine is | 1. Mower clogged with grass. | 1. | Clear clippings from under | |
difficult to |
|
|
| mower. (Allow the mower to |
restart |
|
|
| clear clippings before |
|
|
| shutting off engine.) | |
|
|
|
| |
Poor cut quality | 1. Worn blade. | 1. | Check blade (see CHECK | |
|
|
|
| MOWER BLADE on |
| 2. | Too much grass is being |
| page 18). |
| 2. | Raise cutting height. | ||
|
| removed per cutting. |
|
|
| 3. | Grass is too wet. | 3. | Allow grass to dry. |
| 4. | Mowing speed is too fast. | 4. | Mow slower. |
|
|
|
|
|
EN - 24