Ariens 911175 Signal Words, Safety Decals, Safety Alert Symbol, Safety Decal Identification

Page 4

SAFETY

Read these safety rules and follow them closely. Failure to follow these rules could lead to loss of control of unit, severe personal injury or death to you or bystanders or result in damage to property or the machine.

WARNING: This cutting machine is capable of amputating hands and feet and throwing objects. Failure to observe the safety instructions in the manuals and on decals could result in serious injury or death.

Safety Alert Symbol

These are safety alert symbols. They mean:

ATTENTION!

YOUR SAFETY IS INVOLVED!

When you see this symbol:

BECOME ALERT!

OBEY THE MESSAGE!

SIGNAL WORDS

The safety alert symbols above and signal words below are used on decals and in this manual.

Read and understand all safety messages.

1. Danger

DANGER: Indicates an

IMMINENTLY HAZARDOUS SITUATION! If not avoided, WILL RESULT in death or serious injury.

2. Warning

WARNING: Indicates a

POTENTIALLY HAZARDOUS SITUATION! If not avoided, COULD RESULT in death or serious injury.

3. Caution

CAUTION: Indicates a

POTENTIALLY HAZARDOUS SITUATION! If not avoided, MAY RESULT in minor or moderate injury. It may also be used to alert against unsafe practices.

4. Notice

NOTICE: Indicates information or procedures that are considered important but not hazard related. If not avoided property damage could result.

5. Important

IMPORTANT: Indicates general reference information worthy of special attention.

SAFETY DECALS

This cutting machine is capable of amputating hands and feet and throwing objects. Failure to observe the following safety instructions could result in serious injury or death.

The safety decals on your machine are visual reminders of the important safety information found in this manual. All messages found on your unit must be fully understood and carefully followed. Safety decals found on the machine are explained below.

Always replace missing or damaged safety decals. Replacement decals can be found in the parts manual for your machine and ordered from your dealer.

Refer to Figure 2 for Safety Decal locations.

1.Safety Decal Identification

1

2

KEEP HANDS and FEET AWAY

07800404

Figure 2

EN - 4

Image 4
Contents Razor Walk-Behind Lawn Mower Table of Contents IntroductionUnauthorized Replacement Parts Product RegistrationDisclaimer Dealer DeliverySafety Signal WordsSafety Decals Safety Alert SymbolSafety Decal Description Amputation HazardSafety Rules Operating Conditions OperationSlope Operation Fuel AccessoriesBatteries Transporting Unit ServiceStorage Assembly AssemblyCarton Contents 911175 Controls and Features Cutting Height Adjustment Controls and FeaturesOperation Ignition Switch Optional ControlsFilling Fuel Tank RUN Position 1 AllMower SET-UP To Bag ClippingsGrass Bag Removal To Discharge Clipping to the SideEmergency Stopping Starting and Shut OFFMaintenance Check Mower Blade Sharpen the Mower BladesCheck AIR Cleaner Check Drive BeltCheck Fasteners Change Engine OILService Position Service and AdjustmentsHandlebar Height Drive Belt Replacement 911175 To Remove Drive BeltBattery AdjustmentENGINE/BLADE Control Check The Adjustment Wheel Drive Control AdjustmentTo Adjust Troubleshooting StorageService Parts Specifications 911173 911175 911179Consumer Mowing Equipment Limited Warranty Limitation of Remedy and Damages Disclaimer Ariens West Ryan Street Brillion, WI Fax