Ariens 935335 42 To Check Brake, To Adjust Steering Wheel Alignment, Front Wheel TOE-IN/CAMBER

Page 22

SERVICE AND ADJUSTMENTS

TRANSAXLE MOTION CONTROL LEVER NEUTRAL ADJUSTMENT (See Fig. 33 and 34)

The motion control lever has been preset at the factory and adjustment should not be necessary.

•Engage the freewheel control lever. (See "TO TRANS- PORT" in the Operations section of this manual.)

•Move the motion control lever until the unit rolls freely.

•While holding motion control lever in place, loosen the adjustment bolt.

•Move motion control lever to the neutral (lock gate) position.

•Tighten adjustment bolt securely.

NOTE: If additional clearance is needed to get to adjustment bolt, move mower deck height to the lowest position.

MOTION CONTROL

NEUTRAL

LEVER

LOCK

 

GATE

 

ADJUSTMENT

 

BOLT

Fig. 33

After above adjustment is made, if the tractor does not reach full forward or reverse speed at the furthest motion control lever location for forward and reverse, follow these steps.

•Lower attachment lift lever to it's lowest position.

•Move the shift plate on front of transmission so that the extruded area centerline is in line with the dynamic brake arm. (See Fig. 34)

•While holding motion control lever in place, loosen the adjustment bolt.

•Move motion control lever to the neutral (lock gate) position.

•Tighten adjustment bolt securely.

TRANSMISSION

 

SHIFT PLATE

DYNAMIC

EXTRUSION

BRAKE ARM

 

Fig. 34

TO CHECK BRAKE

If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be serviced.

You may also check brake by:

1.Park tractor on a level, dry concrete or paved surface, depress brake pedal all the way down and engage parking brake.

2.Disengage transmission by placing freewheel control in “transmission disengaged” position. Pull freewheel control out and into the slot and release so it is held in the disengaged position.

The rear wheels must lock and skid when you try to manu- ally push the tractor forward. If the rear wheels rotate, then the brake needs to be serviced. Contact a qualified service center.

TO ADJUST STEERING WHEEL ALIGNMENT

If steering wheel crossbars are not horizontal (left to right) when wheels are positioned straight forward, remove steer- ing wheel and reassemble per instructions in the Assembly section of this manual.

FRONT WHEEL TOE-IN/CAMBER

The front wheel toe-in and camber are not adjustable on your tractor. If damage has occurred to affect the front wheel toe-in or camber, contact your nearest authorized service center/department.

TO REMOVE WHEEL (See Fig. 35)

•Block up axle securely.

•Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).

•Repair tire and reassemble.

•On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

•Replace washers and snap retaining ring securely in axle groove.

•Replace axle cover.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

RETAINING WASHERS

RING

AXLE

COVER

SQUARE KEY (REAR

WHEEL ONLY)

Fig. 35

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Hydro Tractor General Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope OperationIII. Children ServiceIV. Towing Table of Contents Unassembled Parts Steering WheelTo Remove Tractor from Carton AssemblyTools Required for Assembly Before Removing Tractor from SkidInstall Seat See Fig Operation Know Your Tractor Stopping See Fig HOW to USE Your TractorTo SET Parking Brake See Fig To USE Throttle Control D See FigTo Operate Mower To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To Stop Mower BladesTowing Carts and Other Attachments Before Starting the EngineReverse Operation System ROS Check Engine OIL LevelTo Start Engine See Fig Mowing TipsAutomatic Transmission Warm UP General Recommendations MaintenanceMaintenance ScheduleBlade Care BatteryTractor Blade Removal See FigEngine Spark Plugs CleaningMuffler IN-LINE Fuel Filter See FigTo Install Mower See Service and AdjustmentsTo Remove Mower See Fig Install belt on engine pulley M, in belt keepers G To Level Mower Turn nut right Turn nut left To raise mower To lower mowerTo Replace Motion Drive Belt See Fig Belt InstallationTo Replace Mower Blade Drive Belt See Fig Belt RemovalFront Wheel TOE-IN/CAMBER To Adjust Steering Wheel AlignmentTo Check Brake To Remove Wheel See FigTo Attach Jumper Cables To Start Engine with a Weak Battery See FigReplacing Battery See Fig To Remove CABLES, Reverse OrderTo Adjust Carburetor To Adjust Throttle Control CableTo Adjust Choke Control To Replace Headlight BulbFuel System StorageOther Engine OILTroubleshooting Fires when turn To run when operBattery will not Engine continuesService Notes Only Ride UP and Down Hill Not Across Hill Degrees MAX Fold Along This Dotted Line Degree SlopePage Page Page Avertissement Page Page Degrés ’ENTRETIEN Remarques Dépannage DE Guide Moteur le quand ieuxPuissance de Entreposage Réglages ET Révision Starter DU Commande LA Régler PourGAZ DES Commande LA DE Câble LE Régler Pour Moteur37 .Fig Fig la Voir Batterie LA Replacer36 .Fig Tionrecdi RossageAVANT/CAR Roues DES Convergence LA DE L’ALIGNEMENT Régler Pour32 .Fig Fig la Voir D’ENTRAÎNEMENT Courroie LA Remplacer PourFig la Voir Tondeuse DE Lame DE Courroie LA Remplacer Pour 31 .Fig29 .Fig Tondeuse LA Niveau LE Ajuster Pour30 .Fig 28 .Fig23 .Fig 26 .Fig25 .Fig 22 .FigTondeuse LA Enlever Pour Fig la Voir21 .Fig ’ALLUMAGE Bougie Ligne EN Installé D’ESSENCE FiltreEntretien SilencieuxAIR À Filtre Fig la Voir Ventilation DE Système’AIR Tamis LE Nettoyer Moteur DE D’HUILE FiltrePneus Fig la Voir Lame LA EnleverLames DES Entretien Frein DU FonctionnementUtilisation Chaque Avant Ce de Réglages et Etretien section la dans réglages les TousMaauto Transmission LA DE Réchauffement UtilisationQueti 14 .FigROS Arrière Marche EN Fonctionnement DE Système Tondeuse LA Utiliser Pour Jauge DE Roues LES Régler PourTondeuse DE Lames LES Arrêter Pour 10 .FigFig la Voir Mentnetionsta DE Frein LE Engager Pour Fig la Voir Arrêter PourReculer Pour ET Avancer Pour Est Dattachement Dembrayage Levier LE E Trans la débraye Libre Roue LA DE Commande MPermet -DÉPLACEMENT DE Commande DE Levier J ’allumer/ permet Lumières DES Linterupteur HPropriété la de lendommagement Place EN Correctement MontageFrein DE Système LE Vérifier Niveau DE EST Tondeuse LA SI VérifierTionrecdi DE Volant LE Fixer DE Tracteur LE Retirer AvantFig la Voir Batterie LA Vérifier Carton LE DeballerAssemblé PAS Pièces Siège24-18 Réglages ET Révision 31-3027-26 Dépannage DE Guide 17-14Tracteurs des sécurité toute en l’utilisation pour Conseils Sécurité DE RèglesEnfants Entretien’éboule bord le si précipiter de ou bord Pentes LES Dans FonctionnementGénéral Fonctionnement Veuillezlire,comprendreetsuivrelesinstructionsquevoustrouHydrostatique DE Tracteur
Top Page Image Contents