Ariens 935335 42 Tools Required for Assembly, To Remove Tractor from Carton, Unpack Carton

Page 6

ASSEMBLY

Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to ensure proper tightness.

TOOLS REQUIRED FOR ASSEMBLY

A socket wrench set will make assembly easier. Standard wrench sizes are listed.

(1)

5/16" wrench

Utility knife

(2)

7/16" wrenches

Tire pressure gauge

(2) 1/2" wrenches

Pliers

(1)

9/16" wrench

 

When right or left hand is mentioned in this manual, it means when you are in the operating position (seated behind the steering wheel).

TO REMOVE TRACTOR FROM CARTON

UNPACK CARTON

Remove all accessible loose parts and parts cartons from carton.

Cut along dotted lines on all four panels of carton. Remove end panels and lay side panels flat.

Check for any additional loose parts or cartons and remove.

BEFORE REMOVING TRACTOR FROM SKID

TO CHECK BATTERY (See Fig. 1)

Lift seat to raised position.

NOTE: If this battery is put into service after month and year indicated on label (label is located between terminals) charge battery for minimum of one hour at 6-10 amps. (See "BATTERY" in Maintenance section of this manual for charging instructions.)

For battery and battery cable installation see "RE- PLACING BATTERY" in the Service and Adjustments section in this manual.

SEAT

LABEL

TO INSTALL STEERING WHEEL (See Fig. 2)

ASSEMBLE EXTENSION SHAFT AND BOOT

Slide extension shaft onto lower steering shaft.

Place tabs of steering boot over tab slots in dash and push down to secure.

INSTALL STEERING WHEEL

Position front wheels of the tractor so they are pointing straight forward.

Remove steering wheel adapter from steering wheel and slide adapter onto steering shaft extension.

Position steering wheel so cross bars are horizontal (left to right) and slide inside boot and onto adapter.

Assemble large flat washer, lock washer, hex bolt and tighten securely.

Snap steering wheel insert into center of steering wheel.

Remove protective materials from tractor hood and grill.

IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES IN SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR IS TO ROLL OFF SKID.

INSERT

BOLT

LOCK

WASHER

LARGE

FLAT WASHER

STEERING

WHEEL

STEERING

BOOT

ADAPTER

TABS

EXTENSION SHAFT

TAB

SLOTS

LOWER STEERING

SHAFT

02602

Fig. 1

Fig. 2

6

Image 6
Contents Hydro Tractor General Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope OperationService III. ChildrenIV. Towing Table of Contents Unassembled Parts Steering WheelTo Remove Tractor from Carton AssemblyTools Required for Assembly Before Removing Tractor from SkidInstall Seat See Fig Operation Know Your Tractor Stopping See Fig HOW to USE Your TractorTo SET Parking Brake See Fig To USE Throttle Control D See FigTo Operate Mower To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To Stop Mower BladesTowing Carts and Other Attachments Before Starting the EngineReverse Operation System ROS Check Engine OIL LevelMowing Tips To Start Engine See FigAutomatic Transmission Warm UP General Recommendations MaintenanceMaintenance ScheduleBlade Care BatteryTractor Blade Removal See FigEngine Spark Plugs CleaningMuffler IN-LINE Fuel Filter See FigService and Adjustments To Install Mower SeeTo Remove Mower See Fig Install belt on engine pulley M, in belt keepers G To Level Mower Turn nut right Turn nut left To raise mower To lower mowerTo Replace Motion Drive Belt See Fig Belt InstallationTo Replace Mower Blade Drive Belt See Fig Belt RemovalFront Wheel TOE-IN/CAMBER To Adjust Steering Wheel AlignmentTo Check Brake To Remove Wheel See FigTo Attach Jumper Cables To Start Engine with a Weak Battery See FigReplacing Battery See Fig To Remove CABLES, Reverse OrderTo Adjust Carburetor To Adjust Throttle Control CableTo Adjust Choke Control To Replace Headlight BulbFuel System StorageOther Engine OILTroubleshooting Fires when turn To run when operBattery will not Engine continuesService Notes Only Ride UP and Down Hill Not Across Hill Degrees MAX Fold Along This Dotted Line Degree SlopePage Page Page Avertissement Page Page Degrés ’ENTRETIEN Remarques Dépannage DE Guide Moteur le quand ieuxPuissance de Entreposage Réglages ET Révision Starter DU Commande LA Régler PourGAZ DES Commande LA DE Câble LE Régler Pour MoteurFig la Voir Batterie LA Replacer 37 .Fig36 .Fig Tionrecdi RossageAVANT/CAR Roues DES Convergence LA DE L’ALIGNEMENT Régler Pour32 .Fig Fig la Voir D’ENTRAÎNEMENT Courroie LA Remplacer PourFig la Voir Tondeuse DE Lame DE Courroie LA Remplacer Pour 31 .Fig29 .Fig Tondeuse LA Niveau LE Ajuster Pour30 .Fig 28 .Fig23 .Fig 26 .Fig25 .Fig 22 .FigFig la Voir Tondeuse LA Enlever Pour21 .Fig ’ALLUMAGE Bougie Ligne EN Installé D’ESSENCE FiltreEntretien SilencieuxAIR À Filtre Fig la Voir Ventilation DE Système’AIR Tamis LE Nettoyer Moteur DE D’HUILE FiltrePneus Fig la Voir Lame LA EnleverLames DES Entretien Frein DU FonctionnementUtilisation Chaque Avant Ce de Réglages et Etretien section la dans réglages les TousMaauto Transmission LA DE Réchauffement UtilisationQueti 14 .FigROS Arrière Marche EN Fonctionnement DE Système Tondeuse LA Utiliser Pour Jauge DE Roues LES Régler PourTondeuse DE Lames LES Arrêter Pour 10 .FigFig la Voir Arrêter Pour Fig la Voir Mentnetionsta DE Frein LE Engager PourReculer Pour ET Avancer Pour Est Dattachement Dembrayage Levier LE E Trans la débraye Libre Roue LA DE Commande MPermet -DÉPLACEMENT DE Commande DE Levier J ’allumer/ permet Lumières DES Linterupteur HPropriété la de lendommagement Place EN Correctement MontageFrein DE Système LE Vérifier Niveau DE EST Tondeuse LA SI VérifierTionrecdi DE Volant LE Fixer DE Tracteur LE Retirer AvantFig la Voir Batterie LA Vérifier Carton LE DeballerAssemblé PAS Pièces Siège24-18 Réglages ET Révision 31-3027-26 Dépannage DE Guide 17-14Tracteurs des sécurité toute en l’utilisation pour Conseils Sécurité DE RèglesEnfants Entretien’éboule bord le si précipiter de ou bord Pentes LES Dans FonctionnementGénéral Fonctionnement Veuillezlire,comprendreetsuivrelesinstructionsquevoustrouHydrostatique DE Tracteur