American Standard 2425E SERIES Drain Connection and System Test, Post Installation CLEAN-UP

Page 4

WIRE SELECTION GUIDE

 

 

 

 

 

 

 

 

 

 

Maximum distance from

 

 

fusebox to motor

 

Motor

 

 

 

 

 

50'

100'

150'

 

200'

Hi Performance

 

 

 

 

 

Rating

 

120V Power Line

 

1.6

 

 

 

 

 

 

 

 

12

12

10

 

8

 

 

 

 

 

 

The sizes shown on this

chart are recommendations

for copper conductors

only. Always follow

local and national

electrical codes

DRAIN CONNECTION AND SYSTEM TEST

Using recommended drain opening, connect whirlpool drain to waste line. Tighten all drain joints securely. Check the pump couplings and make sure they are hand-tight. Clean the whirlpool and fill with water to a point 2" above the top of the highest jet. Recheck the pump couplings and make certain that they are not leaking. (Although the pump couplings are factory tightened and inspected, some loosening may have occured during transit.) Make sure the whirlpool is connected to the electrical supply and turn the whirlpool on. Check for leaks around all piping connections while the whirlpool is running.

POST INSTALLATION CLEAN-UP

Remove all construction debris from bath. Tile grout can be removed with a wooden popsicle stick or tongue depressor. Do not use wire brushes or any other metal implement on bath surface.

Post installation clean-up generally can be completed using warm water and liquid dishwashing detergent. Stubborn dirt or stains may be removed using granular Spic and Span® mixed with water.

Painter's naphtha can be used to remove excess adhesives and/or wet oil-base paint.

HARSH CHEMICALS SHOULD NEVER BE USED ON ACRYLIC SURFACES.

Abrasive cleaners must not be used since they will scratch and dull the surface. Dulled areas can be restored by rubbing with a white automotive-type polishing compound and waxing with a liquid wax.

752875-100 Rev. D

(4)

SPIC AND SPAN

®

IS A REGISTERED TRADEMARK OF PROCTER & GAMBLE

 

 

Image 4
Contents 2425E Series Whirlpool Installation Instructions General Installation InformationTypical Pier Type Installation Installation and Framing InstructionsElectrical Installation Instructions Separate 15 AMP Maximum Gfci CircuitDrain Connection and System Test Post Installation CLEAN-UPHarsh Chemicals should Never be Used on Acrylic Surfaces