Linn EXOTIK PRE-AMPLIFIER owner manual Back panel, Connecting English

Back panel

1 2

Connecting English

POWER

OFF

ON

OUT RS232 IN

13

SEE UNDERSIDE FOR SAFETY DETAILS
	1	3	MAIN
	1
	2
IR	2	4	ACC/RCU

12 11 10

L

L

L

IN

FRONT

SURR

SURR BK

CENTRE

1/FRONT

2/SURR

3/CENTRE

4

5

6

1

2

R

R

R

OUT

ANALOGUE AUDIO OUTPUTS

SUB

5.1 GROUP

SUB

OUT

3

REMOTE

TAPE OUT

ANALOGUE AUDIO INPUTS

SPDIF

9 8 7 6 5 4 *

OUT		1	INPUTS 2	3
	TOSLINK

3*

	Connector group name:		Connection function	Connector
	Connector marking			type
1		OFF, ON	Mains power switch	-
2		No name or marking	Mains power inlet	IEC
3		* TOSLINK: OUT,	One optical digital audio output and three inputs	4 x TOSLINK
		INPUTS 1 to 3
4		* SPDIF: OUT, INPUTS	One electrical digital audio output and three inputs	4 x RCA
		1 to 3
5		ANALOGUE AUDIO	Three stereo analogue L-R audio inputs	6 x RCA
		INPUTS: 4 L-R, 5 L-R,
		6 L-R
6		ANALOGUE AUDIO	One 5.1 analogue audio input or three stereo	6 x RCA
		INPUTS: 5.1 GROUP -	analogue L-R audio inputs
		1/FRONT L-R, 2/SURR
		L-R, 3/CENTRE L, SUB R
7		TAPE OUT: L-R	One analogue L-R output for connection to a	2 x RCA
			recording device e.g. DAT recorder
	*EXOTIK+DA

Switch off the EXOTIK before connecting plugs to, or disconnecting plugs from, the back panel to avoid generating an electrical surge that may damage the unit or other components of your AV system.

Connector group name:		Connection function	Connector
Connector marking			type
8	ANALOGUE AUDIO	One 7.1 analogue audio output. The SURR outputs	8 x RCA
	OUTPUTS: FRONT L-R,	are for connection to the two surround
	SURR L-R, SURR BK	loudspeakers in a 5.1 system. The SURR BK outputs
	L-R, CENTRE, SUB	are for connection to the two additional loudspeakers
		in a 7.1 system - located at the rear of the room.
		For two-channel systems, use the FRONT outputs
		(and SUB if required) only
9	REMOTE: IN, OUT	RC5 in/out local loop for use in a KNEKT system	2 x RCA
10	ACC/RCU	For installing the EXOTIK in a KNEKT	1 x RJ45
		system or for connection to an infrared repeater
11	1 to 4, MAIN	Used if the EXOTIK is part of a KNEKT system	5 x RJ45
12	IR: 1, 2	Pass IR commands to auxiliary devices	2 x 3.5 mm jack
13	RS232: IN, OUT	Pass control instructions to and from the EXOTIK.	2 x RJ12
		The OUT connection is used if you want to let
		the EXOTIK control another device e.g. a Linn
		UNIDISK player. The IN connection is used
		if you want to control the EXOTIK from a third-
		party home theatre controller

EXOTIK PRE-AMPLIFIER

3 Owner’s Manual