Linn Connecting the AV 5105 Stereo Power Amplifier, Positioning the Stereo Power Amplifier

Page 13

CONNECTING THE AV 5105 STEREO POWER AMPLIFIER

This chapter explains how to unpack your AV 5105 Stereo Power Amplifier, and how to install it with your other hi-fi components.

U n p a c k i n g

The power amplifier comes in a box with the following accessories:

•a mains lead

•two single phono to phono leads

•one spare fuse

•this manual.

We recommend you retain the packaging in case you need to transport the power amplifier at a later date.

WARNING: Do not connect the mains supply until you have verified that the mains voltage switch is set to the correct voltage for your mains supply.

IMPORTANT NOTE FOR UK USE

The wires in this mains lead use the following colour code:

CONNECT THIS WIRE

TO THE TERMINAL

Green and yellow

Marked with the letter E, or by the earth

(Earth)

symbol, or coloured green or green and yellow.

Blue (Neutral)

Marked with the letter N or coloured black.

Brown (Live)

Marked with the letter L or coloured red.

 

 

As the colours of the wires in the mains lead of this appliance may not correspond with the coloured marking identifying the terminals in your plug, proceed as shown in the above table:

1 0 5 S T E R E O P O W E R A M P L I F I E R

VOLTAGE SELECTION

The AV5105 Stereo Power Amplifier is supplied set for 230V operation for use in Europe. To set it for 115V operation disconnect it from the mains and slide the voltage selector switch to the appropriate position.

To fit the fuse, first identify the correct fuse for your local voltage: 3.15 Amp anti-surge for 230V operation, and 6.3 Amp anti-surge for 115V operation. Pull open the fuse drawer under the mains inlet, insert the fuse in the rear compartment, and close the drawer.

WARNING: This appliance must be earthed. Use the earthed moulded mains lead supplied. Never use an unearthed plug or adapter.

POSITIONING THE STEREO POWER AMPLIFIER

The AV5105 is a powerful amplifier and can generate several hundred Watts of heat under extreme use. Both channels are independently protected against overload and over temperature, shutting down until the fault condition is removed.

To make the most of the AV5105 ensure that there is adequate airflow available. Stacking AV5105’s vertically is fine, as long as there is a clear air flow path from bottom to top. If you want to shut them in a cupboard cut big vent holes at the bottom and top of the back, and everywhere else possible. No harm will result from inadequate ventilation, the amplifier will just shut down safely.

C O N N E C T I N G T H E A V 5



Page 12 Page 14
Image 13
Page 12 Page 14
Contents Linn AV Stereo Power Amplifier USER’S Guide General Safety Instructions Important Safety InformationE F a C E Mains PlugsReplacing the Fuse Fuse RatingsMains Voltage Operating Range Positioning the Product and Heat Switching the Product on and OFF Standby OperationCopyright and Acknowledgements Introduction N T E N T SN T E N T S Linn AV System T R O D U C T I O NAV 5103 System Controller AV 5101 Personal Handset AV 5105 Stereo Power AmplifierAV 5120 Compact Loudspeaker AV 5140 FLOOR-STANDING LoudspeakerAV 5150 Active Isobarik Bass Speaker AV 5110 Local Loudspeaker… Making IT Real About the AV 5105 Stereo Power Amplifier Positioning the Stereo Power Amplifier Connecting the AV 5105 Stereo Power AmplifierConnect this Wire To the Terminal Important Note for UK USERear Panel Connections Connecting to the AV 5103 System Controller Connecting to a Stereo PreamplifierN N E C T I O N S Audio InputsE R a T I O N O T E C T I O N A R a N T E E a N D S E R V I C E C H N I C a L I N F O R M a T I O N AV 5105 Stereo Power AmplifierC H N I C a L I N F O R M a T I O N AUDIO D EIntroduction Unpacking Linn AV System Voltage Selection D E
Top Page Image Contents