Exmark Complete Lawn Mower Setup Guide for Installing the StandOn Rider

Setup

Installing the StandOn Rider to Mower

Mounting the Pull Frame

1.Locate the pull frame and two adapter plates. Install the pull frame to the adapter plates using four 3/8-16 x 1 1/4 inch hex capscrews and four 3/8-16 inch nyloc nuts as shown in Figure 4.

4

3

2

1

1

G009397

Figure 4

4

2

Figure 5

1.Remove these two decals.

c.Center the adapter plates on the lower rear surface of the mower engine deck and mark the four hole locations shown in Figure 6. Drill four 0.407 inch diameter holes through the engine deck at the marked locations.

1.3/8-16 inch nyloc nuts

2.Adapter plate

3.Pull frame

4.3/8-16 x 1 1/4 inch hex capscrews

2.Mounting the pull frame assembly to the engine deck:

A.For Turf Tracer and Viking Hydro Units Only:

a.If your unit has four holes drilled in the rear surface of the engine deck proceed to step c; if not, continue with step b.

b.Remove the two decals on the lower rear surface of the engine deck (see Figure 5).

Figure 6

1.Pull frame and adapter plate assembly

2.Mark and drill two holes each side.

d.Apply the two replacement decals to the engine deck between the mounting holes (see Figure 7).

10