Flymo Turbo Compact manual Assembly Instructions, Starting and Stopping

Assembly Instructions

A

Handle slot

C

Grassbox	ly (A)
1. Fit one	of the grassbox lid as illustrated in
Fig. A.	for the other side.

1

2

3

1.	Insert	assembly (B)
		lower handle into the handle slots,
		that the holes are aligned.
2.	In	the pins and secure with the retaining clips.

handle assembly (C)

1 ert the nut into the handle knob. (C1)

2 . lign the holes in the upper and lower handles and

secure with the bolt, washer and wing knob.(C2)

3 . Fit the cable to the handle with the clip provided. (C3) Make sure the cable is not trapped between the upper and lower handles.

Starting and Stopping

D			E		To Start your Lawnmower
					The Flymo Turbo Compact uses an advanced belt drive
					system, between the motor and the blade which
					improves cutting power and flotation in all conditions.
					Due to the high turning force (Torque) which this motor
					develops a light squeak may be heard when the
					machine is started, this is quite normal and will not
					effect the performance of the product
					1.	Connect female extension cable connector to the
						back of the switchbox. (D)
					2.	Form loop in mains cable and push the loop
	F	G				through the slot as illustrated in picture (E)
					3.	To secure, position loop over the hook and pull the
						cable back through the slot as illustrated in picture (F).
					4.	Connect plug to mains and switch on.
					5.	To prevent a ring being cut in your lawn and to
						clear any residual grass in the collection chute, tilt
						your lawnmower slightly (G).
					The switchbox is provided with a lock-off button
					(H1) to prevent accidental starting.
					6.	Press and hold the lock-off button (H) on the
						switchbox, then squeeze one of the Start/Stop
H
				1		levers towards the upper handle (J).
					7.	Continue to squeeze the start/stop lever towards
						the upper handle and release the lock-off button.
					8.	When the lawnmower has reached full speed
						gently lower it onto the lawn.
					NOTE: There are two start/stop levers fitted.
					Either one can be used for starting the lawn-
					mower.
	J				IMPORTANT: Do not use the start/stop levers
					intermittently
					To Stop your Lawnmower
					1.	To prevent a ring being cut in your lawn and to
						clear any residual grass in the collection chute, tilt
						your lawnmower slightly (G).
					2.	Release the pressure on the Start/Stop lever.