Flymo 320 manual Cutting Height Adjustment, Grassbox, Roller and Rear Height Adjustment

Cutting Height Adjustment

Wheels - Front Cutting Height Adjustment

•Height of cut is adjusted by raising or lower- ing the front wheels and rear roller.

•NOTE

The wheels and the roller must be adjusted to the same position:

HEIGHT OF
CUT	WHEEL	ROLLER
Low	Hole 1	Position H
Medium	Hole 2	Position J
High	Hole 3	Position K

•NOTE

A medium height of cut is recommended for most lawns.

1.To remove the wheel assembly turn the wheel hub in an anti-clockwise direction.(E)

2.Select one of the 3 holes in the mounting plate

and note it as the other wheel will need to be adjusted to the same position.(F)

3.Locate fixing bolt through hole in hub cap, wheel and selected hole in mounting plate.(F)

4.Turn the wheel hub in a clockwise direction until

the wheel assembly is securely located to the deck.(E)

5.Using the same height adjustment position repeat the procedure for the other wheel.

Roller and Rear Height Adjustment

H - LOW

J - MEDIUM

K - HIGH

1.Select one of the 3 locations and note it as the

other lever will need to be adjusted to the same position. (H, J or K)

2.Lift the lever out of location and rotate the roller to the desired position. (G)

3.Using the same height adjustment position repeat the procedure for the other lever.

E
to remove	to fit
turn anti-clockwise	turn clockwise
F	wheel
mounting
plate

hub cap

	1
	2
holes	3	fixing bolt
G		H
J		K

Grassbox

Fitting Fully Assembled Grassbox to Lawnmower. See Fig L.

1.Lift safety flap.

2.Make sure the discharge chute is clean and free from debris.

3.Locate fully assembled grassbox onto 2 location points at the rear of the deck

4.Locate safety flap onto the top of the grassbox.

Ensure the grassbox is securely located.

•IMPORTANT !

AFTER FITTING ENSURE NO GAP REMAINS BETWEEN THE SAFETY FLAP AND THE GRASSBOX.

•Removal is the reverse procedure.

•For larger areas of grass where grass collection is not required you can use your lawnmower without the grassbox. Ensure the Safety Flap is fully closed. The design of the safety flap permits the cut grass to be discharged downward behind the machine.

L