Flymo R32 manual Assembly Instructions, Ensure the point of the screw stays inside the handle

3

CABLES			MAINS PLUG REPLACEMENT
IMPORTANT			IMPORTANT
•	Use only 1.00mm	2 size cable up to 30 metres	•		If the plug supplied is cut off it should be
	length maximum.				destroyed. There is an electric shock hazard if a
Maximum rating :					cut off plug is inserted into a 13 amp socket.
1.00mm 2 size cable, 10 amps 250 volts AC.			1.		No earth required. Flymo products are double
•	THE RE320/RE32/R32 IS SUPPLIED WITH				insulated to EN60335 and under no circumstances
	CABLE WIRED DIRECTLY INTO THE PRODUCT.				should an earth be connected to any part of the
1.	Flymo Mains Cables and Extension Cables are				product.
	available from your local Electrolux Outdoor		2.		Ensure the mains voltage suits your product
	Products Approved Service Centre.		3.		IMPORTANT!
2. Do not wire an extension cable directly to your					The wires in the mains lead are coloured in accor-
	product yourself.	Please contact your local			dance with the following code:
	Electrolux Outdoor Products Approved Service				BLUE	-	NEUTRAL
	Centre for further information on the connectors				BROWN	-	LIVE
	and kits available.				The wire which is coloured BLUE must be connect-
3. Only use extension cables specifically designed for					ed to the Terminal which is marked with the letter
	outdoor use.				'N' or coloured BLACK.
CONNECTORS					The wire which is coloured BROWN must be con-
IMPORTANT					nected to the Terminal which is marked with the let-
•	Flymo connectors are suitable for use with 2 core				ter 'L' or coloured RED.
	cable only. Under no circumstances should these		4.		It is important that the outer sheath is clamped cor-
	connectors be used for earthed products.				rectly into the 3-pin plug.
•	All Flymo connectors and cables are of splashproof		5.		If in doubt consult your local Service Repairer or
	construction. They are not waterproof and must				qualified electrician before the machine is used.
	not be left outside permanently nor should they be		6.		A 13 Amp fuse must be fitted to the Mains Plug.
	submerged or immersed in water. Do not let cable		7.		The normal plug fuse and household fuse only pro-
	lay or trail through pools of water or splashed with				tect the electrical equipment and are not a safe-
	water from hose pipes.				guard against	electrocution.
				If your product is hard wired i.e. non-detachable
				mains electric cable, a conversion kit and exten-
				sion cable is available from all Electrolux Outdoor
				Products Approved Service Centres which can be
				found in your local Yellow Pages.
		Assembly Instructions

A

ensure the point of the screw stays inside the handle.

B
C	D

Assembly of Lower Handles to Deck

1.Locate 2 screws into the holes in the handles.

2.Using a pozidrive screwdriver, secure the screws into the lower handles, ensuring the

point of the screw stays inside the handle. (A)

3.Insert lower handles with screws attached, into

the deck and fully tighten screws.	(B)
NOTE:

The screw will form its own thread.

Assembly of Upper Handles to Lower Handles.

1.Ensure the upper handle is located correctly with the lock-off button on the switchbox upper- most.

2.Ensure the upper handle and the lower handle

are aligned correctly. (C)

3.Insert the nut into the handle knob. (if applica- ble)

4. Fit the bolts, washers and handle knobs. (C)

5.Fit the cable to the handles with the clips provid- ed. Make sure the cable is not trapped between the upper and lower handles.

Grassbox Assembly (D)

1.Locate grassbox upper into grassbox lower.

Align clips, ensure all clips are correctly located.

2.Clip the two halves together.

3.Ensure all clips are securely connected.