Flymo R32 manual Cutting Height Adjustment, Grassbox, Turn the wheel

4

Cutting Height Adjustment

•Height of cut is adjusted by raising or lower- ing the wheels.

•NOTE

All 4 wheels must be adjusted to the same position:

HEIGHT OF CUT	WHEELS
Low	Hole 1
Medium	Hole 2
High	Hole 3

•NOTE

A medium height of cut is recommended for most lawns.

E
to remove	to fit
turn anti-clockwise	turn clockwise

1.	To remove the wheel assembly		turn the wheel			F
	hub in	an anti-clockwise direction.			(E)
2.	Select one of the 3 holes in the			mounting plate			wheel
	and note it as the other 3 wheels will need to be
	adjusted to the same position.			(F)		mounting
3.	Locate fixing bolt through hole in hub cap, wheel					plate	hub cap
	and selected hole in mounting plate.				(F)
4.	Turn the wheel hub in a clockwise direction until
	the wheel assembly is securely located to the						1
	deck.	(E)					2
5.	Using the same height adjustment position						3
	repeat the procedure for the other 3 wheels.					holes	fixing bolt
						Grassbox
						G

Fitting Fully Assembled Grassbox to

Lawnmower. See Fig G.

1.Lift safety flap.

2.Make sure the discharge chute is clean and free from debris.

3.Locate fully assembled grassbox onto 2 location points at the rear of the deck

4.Locate safety flap onto the top of the grassbox.

Ensure the grassbox is securely located.

•IMPORTANT !

AFTER FITTING ENSURE NO GAP REMAINS BETWEEN THE SAFETY FLAP AND THE GRASSBOX.

•Removal is the reverse procedure.

•For larger areas of grass where grass collection

is not required you can use your lawnmower without the grassbox. Ensure the Safety Flap is fully closed. The design of the safety flap per- mits the cut grass to be discharged downward behind the machine.