Hayter Mowers 455E manual Operating Tips, Mowing with the Grass Bag, General Tips, Cutting Grass

Page 15

Mowing with the Grass Bag

A worn grass bag could allow small stones and other similar debris to be thrown in the operator’s or bystander’s direction and result in serious personal injury or death to the operator or bystanders.

Check the grass bag frequently. If it is damaged, install a new Hayter replacement bag.

Operating Tips

General Tips

•Maintain a sharp blade throughout the cutting season. Periodically file down nicks on the blade.

•Replace the blade when necessary with an original Hayter replacement blade.

•Mow only dry grass or leaves. Wet grass and leaves can build up and clog in the chute or cause the engine to stall.

Wet grass or leaves can cause serious injury if you slip and contact the blade.

Mow only in dry conditions.

•Clean under the mower housing after each mowing. See Cleaning under the Mower Housing.

•Keep the engine in good running condition.

•Set the engine speed to the fastest position for the best cutting results.

Operating a mower with its engine running at a speed greater than the factory setting can cause the mower to throw a part of the blade or engine into the operator’s or bystander’s area and result in serious personal injury or death.

–Do not change the engine speed setting.

–If you suspect the engine speed is faster than normal, contact an Authorized Service Dealer.

•Clean the air filter frequently. Mulching stirs up more clippings and dust which clogs the air filter and reduces engine performance.

Cutting Grass

•Grass grows at different rates at different times of the year. In the summer heat, it is best to cut grass at the 2-1/2 inch (64 mm), 3 inch (76 mm), or 3-1/2 inch (89 mm) cutting height settings. Cut only about a third of the grass blade at a time. Do not cut below the 2-1/2 inch (64 mm) setting unless the grass is sparse or it is late fall when grass growth begins to slow down.

•When cutting grass over 6 inches (15 cm) tall, first mow at the highest cutting height setting and walk slower; then mow again at a lower setting for the best lawn appearance. If the grass is too long and the leaves clump on top of the lawn, the mower may clog and cause the engine to stall.

•Alternate the mowing direction. This helps disperse the clippings over the lawn for even fertilization.

If the finished lawn appearance is unsatisfactory, try one or more of the following:

•Sharpen the blade.

•Walk at a slower pace while mowing.

•Raise the cutting height on your mower.

•Cut the grass more frequently.

•Overlap cutting swaths instead of cutting a full swath with each pass.

•Set the cutting height on the front wheels one notch lower than the rear wheels. For example, set the front wheels at 2-1/2 inches (64 mm) and the rear wheels at 3 inches (76 mm).

Cutting Leaves

•After cutting the lawn, ensure that half of the lawn shows through the cut leaf cover. You may need to make more than one pass over the leaves.

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents 21in Heavy-Duty Walk-Behind Rotary Mower Introduction ContentsPetrol SafetyGeneral Lawn Mower Safety TrainingOperation Maintenance and StoragePreparation StartingSound Power Sound PressureVibration, Hand/arm 110-2115 Safety and Instructional DecalsProcedure SetupInstalling the Handle Parts needed for this procedureInstalling the Fuel Tank and the Fuel Line No Parts Required ProcedureFilling the Crankcase with Oil Controls SpecificationsThrottle settings are shown in Figure Product OverviewService Interval Before each use or daily OperationChecking the Engine Oil Level Clean around the fuel tank cap Figure Filling the Fuel TankRemove the cap from the tank Engaging the Blade Starting the EngineOperating the Blade Stopping the EngineAdjusting the Cutting Height Operating the Traction DriveChecking the Blade Brake Clutch Lower the rear door Using the Grass BagInstalling the Grass Bag Removing the Grass BagCutting Grass Operating TipsMowing with the Grass Bag General TipsPage Lubricating the Pivot Arms MaintenanceRecommended Maintenance Schedules LubricationEngine Maintenance Lubricating the Gear CaseServicing the Air Filter Changing the Oil Filter Changing the Engine OilServicing the Spark Plug Install the new filter and hand tighten it 2/3 turn onlyAdjusting the Self-propel Drive Fuel System MaintenanceDrive System Maintenance Emptying the Fuel Tank and Cleaning the Fuel FilterRemove the screws from the lower anchor bracket Figure Servicing the WheelsRemoving the Wheels Assembling the WheelsAdjusting the Blade Brake Cable Controls System MaintenanceSpring Cable clamp screw Brake cable conduit Inspecting the Blade Blade MaintenanceMaintaining the Cutting Blade Removing the BladeCleaning under the Mower Housing CleaningTip the mower on its right side Cleaning the Blade Brake Clutch ShieldGeneral Information StoragePreparing the Fuel System Preparing the EngineProblem Possible Cause Corrective Action TroubleshootingPage Limited Warranty Date of Sale Your Local Dealer

455E specifications

The Hayter Mowers 455E is a standout choice for homeowners and garden enthusiasts seeking a reliable and efficient lawn mower. This robust machine is designed for high performance, making lawn care easy and enjoyable. With a passion for quality and craftsmanship, Hayter continues to build on its reputation for creating exceptional gardens and outdoor spaces.

One of the main features of the 455E is its 4-in-1 functionality, offering the capability to mow, mulch, side discharge, and collect grass clippings. This versatility allows users to tailor their mowing experience based on lawn conditions and personal preferences. The mower’s 53 cm cutting width is perfect for medium to large lawns, enabling a quicker and more efficient mowing process.

The 455E is powered by Hayter’s innovative electric start system. Unlike traditional mowers, which require pulling a cord to start, the electric start technology simplifies the process with the push of a button. This feature is especially beneficial for those who may find manual starting challenging. The mower is equipped with a powerful 158cc Loncin engine that delivers reliable performance and excellent fuel efficiency, allowing for longer mowing sessions without frequent refueling.

Additionally, the Hayter Mowers 455E features a fully adjustable cutting height, ranging from 25mm to 70mm. This allows users to achieve their desired grass length and maintain a healthy lawn throughout the seasons. The mower also boasts a robust steel deck construction, ensuring durability and stability during use. The quality of the materials used in its manufacture underlines Hayter’s commitment to providing long-lasting, dependable garden solutions.

Comfort is another focus of the 455E design. With an ergonomic handle that can be adjusted to different heights, users can mow their lawns without unnecessary strain. The foldable handles further add to the product's convenience, making storage easy and efficient.

In summary, the Hayter Mowers 455E combines advanced technology, versatility, and user-centric features to deliver an outstanding lawn care experience. Its 4-in-1 capabilities, electric start, powerful engine, adjustable cutting heights, and comfortable design make it a top choice for anyone looking to keep their lawn in pristine condition. With the 455E, maintaining a beautiful garden has never been easier.
Top Page Image Contents