Introduction | Heart & Home Collectables GFK-210 instruction

GFK-210 Blower System

- Installation and Operating Instructions -

1.0 INTRODUCTION

The GFK-210 Blower System has been designed to circu- late room air through the ﬁreplace to enhance heat output. The GFK-210 blower system operates on 120 VAC, 60 Hz power. This is available through a receptacle in the factory installed power cord assembly. The power cord is located in the controls compartment of the ﬁreplace.

A variable speed control is provided with the blower system to provide quiet forced air ﬂow at the desired speeds. A temperature sensor switch, which automatically turns the blower ON/OFF, is also provided with this kit.

This blower is carefully engineered and must be installed only as speciﬁed. If you modify it or any of its components, you may cause a ﬁre hazard and will void the WARRANTY. In addition, such action may void the coverage provided by the owner's home insurance.

CAUTION: All wiring should be done by a qualiﬁed electri- cian and shall be in compliance with local codes and with the National Electric Code ANSI/NFPA NO. 70-current (in the United States), or with the current CSA C22.1 Canadian Electric Code (in Canada).

CAUTION! DO NOT connect 110-120 VAC wiring to the gas control valve of the ﬁreplace.

	NOTICE: The variable speed control and temperature	WARNING! Risk of Shock! Turn electrical power off at
	sensor switch are not used with some remote control
		the circuit breaker before beginning this installation.
	systems.

2.0 CHECK CONTENTS OF SHIPPING CARTON

Compare CONTENTS OF CARTON in Figure 1 with the actual parts received. If any parts are missing or damaged, contact your dealer before starting installation. Do not install a damaged blower kit.

4.0 INSTALLING THE BLOWER (Metal Inserts)

1.	Remove factory-installed blower brackets by removing
	four screws. Brackets are only used for the FireBrick
	inserts. See Figure 2.
2.	Remove appliance from wall.
3.	Remove access panel by removing four screws. See
	Figure 3.
4.	Screw blowers to access panel on rear of insert with
	four screws. See Figure 4.
5.	Plug the blower cord into the blower receptacle. Con-
	nect the white, black, and green spade connectors
	from blower cord harness to each blower. See Figure
	1 and Figure 6.

CONTROL

WING

NUT

060-872

BLOWER CORD

2206-068

TEMPERATURE

SENSOR

SWITCH

6.	Bundle and zip tie any wires to keep them from contact-
	ing the fan blades. See Figure 6, Detail A.
7.	Reinstall access panel.

NOTE: Install the blower using the access panel located on the back side of the appliance.

KNOB

100-512

CONTROL

NUT

060-814

046-018A

VARIABLE SPEED CONTROL

2206-800

Figure 1

3.0 INSTALLATION PRECAUTIONS

The GFK-210 Blower Kit is tested and safe when installed in accordance with this installation manual. It is your responsi- bility to read all instructions before starting installation and to follow these instructions carefully during installation to assure maximum beneﬁt from, and safe operation of, the blower.

Figure 2 Remove Blower Brackets

Hearth & Home Technologies • GFK-210 Blower System Instructions 2206-938 Rev. H • 7/11