Husqvarna 96045000502 owner manual First Install ANTI-SWAY BAR S

Page 19

SERVICE AND ADJUSTMENTS

02965

FIG. 18

A

02965

FIG. 19

NOTE: Be sure mower side suspension arms (A) are pointing forward before sliding mower under tractor.

Slide mower under tractor until it is centered under tractor.

FIRST INSTALL ANTI-SWAY BAR (S).

-From right side of mower, insert anti-sway bar into hole in transmission bracket (T).

-Pivot bar towards you and insert other end of bar into hole in rear mower bracket (D). Move mower as needed to insert bar.

-Secure with washer and retainer spring as shown.

D

FIG. 21

ATTACH MOWER SIDE SUSPENSION ARMS (A) TO CHASSIS - Position hole in arm over pin (B) on outside of tractor chassis and secure with washer and retainer spring.

Repeat on opposite side of tractor.

A

B

FIG. 22

ATTACH REAR LIFT LINKS (C) - Lift rear corner of mower and position slot in link assembly over pin on rear mower bracket (D) and secure with washer and retainer spring.

Repeat on opposite side of tractor.

T

S

 

C

 

 

 

 

 

 

D

A

 

 

 

 

 

 

FIG.23

 

 

02995

• Turn steering wheel to position wheels straight for-

 

 

 

 

FIG. 20

 

ward.

19

Image 19
Contents YTH2348 II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceGeneral Service III. ChildrenTable of Contents Unpack Carton AssemblyUnassembled Parts To Remove Tractor from CartonCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Reverse Operation System ROS on Position Know Your TractorStopping HOW to USE Your TractorTo Move Forward and Backward To Operate Mower To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig System CharacteristicsTo Operate on Hills Service REMINDER/HOUR MeterUsing the Reverse Operation System Reverse Operation System ROSTo Start Engine See Fig Before Starting the EngineCheck Engine OIL Level ADD GasolinePurge Transmission Mowing TipsSchedule MaintenanceMaintenance General RecommendationsTires BatteryTractor Brake OperationTransaxle Pump Fluid EngineBelts Transaxle CoolingCleaning To Install Mower See Figs Service and AdjustmentsTo Remove Mower See Fig First Install ANTI-SWAY BAR S LBF Turn nut right Turn nut left To raise mower To Level MowerTo Replace Mower Blade Drive Belt See Fig Mower Drive Belt InstallationMower Drive Belt Removal To Remove Wheel for Repairs See Fig To Replace Motion Drive Belt See FigTo Check Brake Front Wheel TOE-IN/CAMBERTo Replace Headlight Bulb To Start Engine with a Weak Battery See FigReplacing Battery See Fig Weak or Dead Fully Charged BatteryTo Adjust Carburetor To Remove Hood and Grill Assembly See FigTo Adjust Throttle Control Cable To Adjust Choke ControlEngine OIL StorageOther Fuel SystemProblem Cause Correction Troubleshooting PointsEngine dies when Tractor Model NO. YTH2348 96045000502, Product no 45 SchematicElectrical KEY Part Description Chassis KEY Part NO. NO. Description 532 19  DriveTractor Model NO. YTH2348 96045000502, Product no 45 30!2+ª!22%34%2ª+4 EngineSeat Assembly 65 532 19 Steering AssemblyWheels and Tires DecalsMower Deck KEY Part NO. NO. Description Mower Lift Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe Operation1SECTION Statementwarranty Arrantyw Limited