Husqvarna 55B21HV Assembly, HOW to SET UP Your Lawn Mower, To Remove Lawn Mower from Carton

Page 4

ASSEMBLY

Read these instructions and this manual in its entirety before you attempt to assemble or operate your new lawn mower.

IMPORTANT: THIS LAWN MOWER IS SHIPPED WITH- OUT OIL OR GASOLINE IN THE ENGINE.

Your new lawn mower has been assembled at the factory with the exception of those parts left unassembled for ship- ping purposes. All parts such as nuts, washers, bolts, etc., necessary to complete the assembly have been placed in the parts bag. To ensure safe and proper operation of your lawn mower, all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to ensure proper tightness.

TO REMOVE LAWN MOWER FROM CARTON

1.Remove loose parts included with mower.

2.Cut down two end corners of carton and lay end panel down fl at.

3.Remove all packing materials except padding between upper and lower handle and padding holding operator presence control bar to upper handle.

4.Roll lawn mower out of carton and check carton thor- ougly for additional loose parts.

HOW TO SET UP YOUR LAWN MOWER

TO UNFOLD HANDLE (See Figs. 1 and 2)

IMPORTANT: UNFOLD HANDLE CAREFULLY SO AS NOT TO PINCH OR DAMAGE CONTROL CABLES.

1.Raise lower handle to operating position and align hole in handle with one of the height positioning holes in the handle bracket.

2.Insert handle bolt through handle and bracket and secure with knob.

3.Repeat for opposite side of handle.

4.Remove protective padding, raise upper handle sec- tion into place on lower handle and tighten both handle knobs.

5.Remove packing material from around control bar.

Your handles may be adjusted for your mowing comfort. Refer to“ADJUST HANDLE”in the Service and Adjustments section of this manual.

OPERATOR PRESENCE

CONTROL BAR

UPPER HANDLE

LOWER HANDLE

LIFT UP

 

LIFT

UP

MOWING

POSITION

FIG. 1

BOLT

KNOB

HANDLE

BRACKET

FIG. 2

4

Image 4
Contents 55B21HV IV. Service Safe Operation Practices for Walk-Behind MowersGeneral Operation III. ChildrenTable of Contents Assembly HOW to SET UP Your Lawn MowerTo Remove Lawn Mower from Carton To Unfold Handle See FigsTo Install Attachments To Assemble Grass Catcher See FigsOperation Meets Cpsc Safety RequirementsKnow Your Lawn Mower HOW to USE Your Lawn Mower Drive Control Adjustment See FigThrottle / Engine Control See Fig Blade Control See FigTo Adjust Cutting Height See Fig To Convert Mower See Figs thruSimple Steps to Remember When Converting Your Lawn Mower To Empty Grass Catcher See FigsBefore Starting Engine ADD OIL See FigsADD Gasoline See Fig To Stop EngineMowing Tips Mulching Mowing TipsMaintenance Lubrication ChartGeneral Recommendations Before Each USELawn Mower EngineService and Adjustments CleaningTo Remove Drive Belt See Figs To Replace Drive Belt See FigsTo Adjust Handle See Fig StorageEngine Speed CarburetorOther Handle See FigsFuel System Engine OILTroubleshooting Points Problem Cause CorrectionRotary Lawn Mower - Model Number 55B21HV 55B21HVA Gear Case Assembly - Part Number 532 18KEY Part Description Page KEY Part Description Page 532 19 Statementwarranty