Husqvarna 532 44 00-55 Turn Steering Wheel Left and Position Mower See Fig, Anti-Sway Bar S

Page 7

ASSEMBLY

CAUTION: Continuing to press the electric lift switch after the mower deck has reached the minimum or maximum position may result in damage to the electric lift mechanism.The electric lift mechanism is equipped with a thermal protection system. If the system overheats or fails to operate, allow the system to cool before attempting to operate again.

2.ASSEMBLE FRONT GAUGE WHEEL (W) TO FRONT OF MOWER (See Fig. 4)

4. SLIDE MOWER UNDER TRACTOR (See Fig. 7)

•Bring belt forward and check belt for proper routing in all mower pulley grooves.

NOTE: Be sure mower side suspension arms (A) are point- ing forward before sliding mower under tractor.

•Slide mower under tractor until it is centered under tractor.

Q

H

W

X

Z

Y

H.FRONT MOWER BRACKET

W. FRONT GAUGE WHEEL

X.SHOULDER BOLT

Y.1-1/4 O.D.

WASHER

Z.3/8-16 LOCKNUT

A	A. MOWER SIDE
	SUSPENSION

Fig. 4

3.TURN STEERING WHEEL LEFT AND POSITION MOWER (See Fig. 5)

•Turn steering wheel to the left as far as it will go and position mower on right side of tractor with deflector shield (Q) to the right.

	ARMS
	Q. DEFLECTOR
02965	SHIELD
	SHIELD

Fig. 7

5.INSTALL ANTI-SWAY BAR (S) (IF EQUIPPED) (See Fig. 8 - 10)

FRONT

Q

ENGINE

TRANSAXLE

Q. DEFLECTOR

BACK02965SHIELD

Fig. 5

ANTI-SWAY BAR (S)
TOWARDS	TOWARDS
TRANSAXLE	MOWER DECK
90° END	INTEGRATED WASHER END

Fig. 8

•From right side of mower, first insert 90° end of anti-sway bar (S) into hole in transaxle bracket (T), located near left rear tire in front of transaxle.

NOTE: Flashlight may be helpful.

B

L A K

C

I

C

S D

M	F		A. MOWER SIDE SUSPENSION
M			A. MOWER SIDE SUSPENSION
				ARMS
	W		B. RETAINER SPRING
	W		C. REAR LIFT LINK(S)
			C. REAR LIFT LINK(S)
			D. RIGHT SIDE REAR MOWER
	E			BRACKET
	E		E. FRONT LIFT LINK ASSEMBLY
			E. FRONT LIFT LINK ASSEMBLY
			F. FRONT SUSPENSION BRACKET
			H. FRONT MOWER BRACKET
			I.	LEFT SIDE REAR MOWER
		H		BRACKET
		H	K. BELT TENSION ROD
			K. BELT TENSION ROD
			L. LOCKING BRACKET
			M. ENGINE CLUTCH PULLEY
			Q. DEFLECTOR SHIELD
			S. ANTI-SWAY BAR
	Q		W. FRONT GAUGE WHEEL

Fig. 6

7

Image 7

Contents LGT2554 II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceGeneral Service III. ChildrenTable of Contents Skid AssemblyTools Required for Assembly Unassembled PartsTo Install Mower and Drive Belt See Figs Adjust Seat See FigSET Parking Brake Lever and Lower AT- Tachment Lift See Fig Turn Steering Wheel Left and Position Mower See Fig Install ANTI-SWAY BAR S if Equipped SeeANTI-SWAY BAR S Attach Rear Lift Links C See Fig Attach Mower Side Suspension Arms a to Chassis See FigAttach Front Link E See Fig Check for Proper Position of ALL Belts Install Belt on Engine Clutch Pulley M SeeCheck Tire Pressure Check Deck LevelnessOperation DPH AC J Know Your TractorTo USE Throttle Control D See Fig HOW to USE Your TractorTo SET Parking BRAKESee Fig Stopping See FigTo Operate Mower To Adjust Gauge Wheels See FigTo Adjust Mower Cutting Height See Fig To Move Forward and Backward See FigTo Transport See Service REMINDER/HOUR MeterReverse Operation System ROS To Operate on HillsTo Start Engine See Fig Before Starting the EngineCheck Engine OIL Level ADD GasolinePurge Transmission Mowing TipsSchedule MaintenanceMaintenance General RecommendationsBlade Removal See Fig BatteryTractor Blade CareEngine IN-LINE Fuel Filter See Fig CleaningDeck Washout Port See Fig To Replace Mower Blade Drive Belt See Fig Service and AdjustmentsTo Install Mower To Remove Mower See FigTo Level Mower To Remove Wheel See Fig To Replace Motion Drive Belt See FigTo Check Brake Front Wheel TOE-IN/CAMBERTo Remove CABLES, Reverse Order Transaxle Motion Control Lever Neutral Adjustment See FigTo Start Engine with a Weak Battery See Fig To Attach Jumper CablesTransmission Engine OIL StorageOther Fuel SystemProblem Cause Correction Engine continues To run when operBattery will not Fires when turnTractor Model NO. LGT2554 96045002800, Product no 45 SchematicElectrical KEY Part Description Chassis Tractor Model NO. LGT2554 96045002800, Product no 45 Drive Bolt Rdhd Sqnk 3/8-16 x 2-3/4 Gr Mower Deck 532 19 56-32 Deck Weldment Mower 30!2+ª!22%34%2ª+4 Engine532 42 Seat Seat AssemblySteering Assembly Mower Lift Wheels and Tires DecalsOnly Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationLimitations and Exclusions HOW to Obtain Service Consumer Wheeled Warranty Chart Front Mounted Deck Riders Engine Transmission 11.02.10 JA