Husqvarna 532 43 00-03, 96045002200 owner manual Unassembled Parts, Tools Required for Assembly

Page 5

UNASSEMBLED PARTS

Slope Sheet

Key

(1) Oil Drain Tube

(2) Keys

ASSEMBLY

Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping puposes.

TOOLS REQUIRED FOR ASSEMBLY

A socket wrench set will make assembly easier. Standard wrench sizes are listed.

(1)

1/2" wrench

Tire pressure gauge

(2)

7/16" wrenches

Utility knife

 

 

Pliers

ADJUST SEAT (See Fig. 2)

Sit in seat.

Lift up adjustment lever (A) and slide seat until a com- fortable position is reached which allows you to press clutch/brake pedal all the way down.

Release lever to lock seat in position.

When right or left hand is mentioned in this manual, it means when you are in the operating position (seated behind the steering wheel).

TO REMOVE TRACTOR FROM CARTON

UNPACK CARTON

Remove all accessible loose parts and parts cartons from carton.

Cut along dashed lines on all four panels of carton. Remove end panels and lay side panels flat.

Check for any additional loose parts or cartons and remove.

A

CHECK BATTERY (See Fig. 1)

FIG. 2

• Lift hood to raised position.

NOTE: You may now roll your tractor off the skid. Follow

 

 

 

NOTE: If this battery is put into service after month and year

the appropriate instruction below to remove the tractor

indicated on label (L) (label is located between terminals)

from the skid.

charge battery for minimum of one hour at 6-10 amps.

WARNING: Before starting, read, understand and follow

(See "BATTERY" in Maintenance section of this manual

all instructions in the Operation section of this manual. Be

for charging instructions).

sure tractor is in a well-ventilated area. Be sure the area in

 

 

 

 

 

 

front of tractor is clear of other people and objects.

 

TO ROLL TRACTOR OFF SKID

(See Op-

 

eration section for location and function of

L

controls)

 

 

Raise attachment lift lever to its highest position.

 

Release parking brake by depressing brake pedal.

• Place freewheel control in disengaged position to dis- engage transmission (See “TO TRANSPORT” in the Operation section of this manual).

02931

• Roll tractor forward off skid.

 

5 Continue with the instructions that follow.

FIG. 1

Image 5
Contents YTH2348 Safe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationGeneral Service ServiceIII. Children IV. TowingTable of Contents Tools Required for Assembly AssemblyUnassembled Parts To Remove Tractor from CartonCheck Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Reverse Operation System ROS on Position Know Your TractorHOW to USE Your Tractor To Adjust Gauge Wheels See Fig To Adjust Mower Cutting Height See FigSystem Characteristics To Operate MowerReverse Operation System ROS Service REMINDER/HOUR MeterTo Transport See Figs To Operate on HillsCheck Engine OIL Level Before Starting the EngineADD Gasoline To Start Engine See FigRunning Mowing TipsPurge Transmission Maintenance MaintenanceGeneral Recommendations ScheduleTractor BatteryBrake Operation TiresEngine Deck Washout Port See Fig CleaningIN-LINE Fuel Filter See Fig To Remove Mower See Fig Service and AdjustmentsTo Install Mower See Figs First Install ANTI-SWAY BAR S LBF Turn nut right Turn nut left To raise mower To Level MowerMower Drive Belt Removal Mower Drive Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Check Brake To Replace Motion Drive Belt See FigFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigReplacing Battery See Fig To Start Engine with a Weak Battery See FigWeak or Dead Fully Charged Battery To Replace Headlight BulbTo Adjust Throttle Control Cable To Remove Hood and Grill Assembly See FigTo Adjust Choke Control To Adjust CarburetorOther StorageFuel System Engine OILProblem Cause Correction Battery will not To run when operFires when turn Engine continuesTractor Model NO. YTH2348 96045002200, Product no 45 SchematicElectrical KEY Part Description Chassis 204 532 41 Vent Top Hood Chassis197 196 DriveTractor Model NO. YTH2348 96045002200, Product no 45 Engine Spark Arrester KITKEY Part NO. NO. Description Engine Power Rating InformationSteering Assembly 532 41 Wheel, Steering 532 19 Mower Deck KEY Part NO. NO. Description Mower Lift Seat Assembly Wheels and Tires DecalsSuggested Guide for Sighting Slopes for Safe Operation Service Notes Service Notes Warranty Statement