Husqvarna 03002, 96045001700, 532 42 57-55 owner manual Schematic, SCH12

Page 29

TRACTOR - MODEL NO. LGT2554 (96045001700), PRODUCT NO. 960 45 00-17

SCHEMATIC

SCH12

A

AMMETER (OPTIONAL)

WHITE

S

B M

	BATTERY	SOLENOID
		SOLENOID	STARTER
			STARTER
	RED		M
RED	FUSE		M
RED
		BLACK
		BLACK
	PTO SWITCH		ELECTRIC CLUTCH
	PTO SWITCH	WHITE	BLACK
	(DISENGAGED)
BLACK	H	WHITE
BLACK
	C

G

A1

GRAY

C F H

B E G

A D

PTO SWITCH

(MATING SIDE)

L A2

BLACK

ORANGE

RED	A	D RED	CLUTCH/BRAKE
	A	D RED	CLUTCH/BRAKE
			(PEDAL UP)
	B	E
		BLACK		REVERSE SWITCH
		BLACK		(NOT IN REVERSE)
				(NOT IN REVERSE)
	BLACK
	BLACK
		2	BLACK
	BLACK	3		SEAT SWITCH
		3	BLACK	(NOT OCCUPIED)
	BLACK	1	BLACK
		1
		6	GRAY
		JUNCTION
		CONNECTOR
	/WHITE			SHORTING
	BLACK			SHORTING
		CHASSIS		CONNECTOR
		CHASSIS
		HARNESS
		IGNITION		SPARK
		UNIT		PLUGS GAP
			(2 PLUGS ON
		(OPTIONAL)	TWIN CYL. ENGINES)
		(OPTIONAL)
	BLUE	HOUR		BLACK
		METER
	FUEL	BLUE		12V	BLACK
	LINE			12V
	LINE
				POWER OUTLET
BLUE				(OPTIONAL)
		CHARGING SYSTEM OUTPUT
	FUEL SHUT-OFF	9 - 1 6 AMP DC @ 3600 RPM
	SOLENOID
	(IF EQUIPPED)	REGULATOR		STATOR
	RED	REGULATOR
	RED
			28 VOLTS AC @ 3600 RPM (REGULATOR DISCONNECTED)
		BROWN			BLACK
	LIGHT
	SWITCH
			HEADLIGHTS

				3	6	6	3
	IGNITION SWITCH
				2	5	5	2
	POSITION	CIRCUIT	“MAKE”
						4	1
	OFF	M+G+A1		1	4

	RUN/OVERRIDE	B+A1
	RUN	B+A1	L+A2	CHASSIS HARNESS		DASH HARNESS
	START	B + S + A1		CONNECTOR		CONNECTOR
				(MATING SIDE)

WIRING INSULATED CLIPS NOTE: IF WIRING INSULATED CLIPS WERE REMOVED FOR SERVICING OF UNIT, THEY SHOULD BE RE-INSTALLED TO PROPERLY SECURE YOUR WIRING.

NON-REMOVABLE CONNECTIONS

REMOVABLE CONNECTIONS

29

Image 29

Contents LGT2554 Safe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationGeneral Service ServiceIII. Children IV. TowingTable of Contents Tools Required for Assembly AssemblyUnassembled Parts Before Removing Tractor from SkidTo Install Mower See Figs To Adjust Seat See FigFirst Install ANTI-SWAY BAR S Assemble Front Wheel to Mower See FigLB M Check Tire Pressure Mower Drive Belt InstallationCheck Deck Levelness Check for Proper Position of ALL BeltsOperation DPH AC J Know Your TractorTo SET Parking BRAKESee Fig HOW to USE Your TractorStopping See Fig To USE Throttle Control See FigTo Adjust Gauge Wheels See Fig To Adjust Mower Cutting Height See FigTo Move Forward and Backward See Fig To Operate MowerUsing the Reverse Operation System Service REMINDER/HOUR MeterTo Transport See To Operate on HillsCheck Engine OIL Level Before Starting the EngineADD Gasoline To Start Engine See FigPurge Transmission Mowing TipsLubrication Chart MaintenanceTractor BatteryBlade Care Blade Removal See FigEngine Cleaning To Install Mower Service and AdjustmentsTo Remove Mower See Fig To Level MowerFront Wheel TOE-IN/CAMBER To Adjust Steering Wheel AlignmentTo Check Brake To Replace Motion Drive Belt See Fig To Replace Mower Blade Drive Belt See FigSlide belt toward rear of tractor, off the steering plate Remove from tractorTo Start Engine with a Weak Battery See Fig Transaxle Motion Control Lever Neutral Adjustment See FigTo Remove Wheel See Fig To Attach Jumper CablesTransmission Other StorageFuel System Engine OILProblem Cause Correction Battery will not To run when operFires when turn Engine continuesKEY Part Description DecalsWheels and Tires SCH12 SchematicElectrical KEY Part Description Chassis 817 00 Drive Bolt Rdhd Sqnk 3/8-16 x 2-3/4 Gr Gasket Engine111 113 109 532 40 Seat Seat Assembly228 Steering Assembly532 42 Wheel, Steering 532 19 Mower Deck 532 40 31-25 Deck Weldment Mower Mower Lift Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationWarranty Statement