Husqvarna 03002 Service and Adjustments, To Remove Mower See Fig, To Install Mower, Dcd

Page 20

SERVICE AND ADJUSTMENTS

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:

Depress brake pedal fully and set parking brake.

Place attachment clutch in “DISENGAGED” position.

Turn ignition key to “STOP” and remove key.

Make sure the blades and all moving parts have completely stopped.

Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

TO REMOVE MOWER (See Fig. 29)

Place attachment clutch in “DISENGAGED” position.

Lower attachment lift lever to its lowest position.

Disengage belt tension rod (K) from lock bracket (L).

CAUTION: Belt tension rod is spring loaded. Have a tight grip on rod and release slowly.

Remove mower belt from electric clutch pulley (M).

Disconnect front link (E) from mower - remove retainer spring and washer.

Gotoeithersideofmoweranddisconnectmowersuspen- sion arm (A) from chassis and rear lift link (C) from rear mowerbracket(D)-removeretainerspringsandwashers.

Go to other side of mower and disconnect the suspen- sion arm and rear lift link.

CAUTION: After rear lift links are discon- nected, the attachment lift lever will be spring loaded. Have a tight grip on lift lever when changing position of the lever.

From right side of mower, disconnect anti-sway bar (S) from right rear mower bracket (D) - remove retainer spring and washer and pull mower toward you until the bar falls from the hole in bracket.

Turn tractor steering wheel to the left as far as it will go.

Slide mower out from under right side of tractor.

TO INSTALL MOWER

Follow procedure described in “INSTALL MOWER AND DRIVE BELT” in the Assembly section of this manual.

TO LEVEL MOWER

Make sure tires are properly inflated to the PSI shown on tires. If tires are over or under inflated, it may affect the appearance of your lawn and lead you to think the mower is not adjusted properly.

VISUAL SIDE-TO-SIDE ADJUSTMENT (See Fig. 30)

Withalltiresproperlyinflatedandifyourlawnappearsun- evenlycut,determinewhichsideofmoweriscuttinglower.

NOTE: As desired, you can raise the low side of mower or lower the high side.

Go to side of mower you wish to adjust.

With a 3/4" or adjustable wrench, turn lift link adjust- ment nut (A) to the left to lower the mower, or, to the right to raise the mower.

 

A

Turn nut right

Turn nut left

to raise mower

to lower mower

Fig. 30

LB M

K

F

A

E

H

CS

DCD

Fig. 29

20

Image 20
Contents LGT2554 Safety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService General ServiceIII. Children IV. TowingTable of Contents Assembly Tools Required for AssemblyUnassembled Parts Before Removing Tractor from SkidTo Adjust Seat See Fig To Install Mower See FigsFirst Install ANTI-SWAY BAR S Assemble Front Wheel to Mower See FigLB M Mower Drive Belt Installation Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor DPH AC JHOW to USE Your Tractor To SET Parking BRAKESee FigStopping See Fig To USE Throttle Control See FigTo Adjust Mower Cutting Height See Fig To Adjust Gauge Wheels See FigTo Move Forward and Backward See Fig To Operate MowerService REMINDER/HOUR Meter Using the Reverse Operation SystemTo Transport See To Operate on HillsBefore Starting the Engine Check Engine OIL LevelADD Gasoline To Start Engine See FigMowing Tips Purge TransmissionMaintenance Lubrication ChartBattery TractorBlade Care Blade Removal See FigEngine Cleaning Service and Adjustments To Install MowerTo Remove Mower See Fig To Level MowerFront Wheel TOE-IN/CAMBER To Adjust Steering Wheel AlignmentTo Check Brake To Replace Mower Blade Drive Belt See Fig To Replace Motion Drive Belt See FigSlide belt toward rear of tractor, off the steering plate Remove from tractorTransaxle Motion Control Lever Neutral Adjustment See Fig To Start Engine with a Weak Battery See FigTo Remove Wheel See Fig To Attach Jumper CablesTransmission Storage OtherFuel System Engine OILProblem Cause Correction To run when oper Battery will notFires when turn Engine continuesKEY Part Description DecalsWheels and Tires Schematic SCH12Electrical KEY Part Description Chassis 817 00 Drive Bolt Rdhd Sqnk 3/8-16 x 2-3/4 Gr Gasket Engine111 113 109 Seat Assembly 532 40 SeatSteering Assembly 228532 42 Wheel, Steering 532 19 Mower Deck 532 40 31-25 Deck Weldment Mower Mower Lift Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXWarranty Statement