ASSEMBLY
1BAGGER SUPPORT ASSEMBLY (See Figures 1A and 1B)
1.Remove rear engine guard by removing the six bolts that attach the guard to the frame.
2.Attach hitch (Part No. 539108014) to the frame using the same holes and same six bolts that attached the rear engine guard.
*NOTE: If your unit does not have the holes or slots on the fenders, you will need to mark and drill them before continuing.
| FENDER |
ENGINE |
|
GUARD | 3/8" HOLE* |
BOLTS |
REAR ENGINE GUARD
3/8" HOLE*
ENGINE | ENGINE | |
GUARD | ||
GUARD | ||
BOLTS | ||
BOLTS | ||
|
FIGURE 1A
3.Using the hardware shown, attach the upper arms of the hitch to the rear fenders of the frame.
| WASHER, 5/16 |
WASHER, | NUT, 5/16, NYLOC |
SPECIAL |
|
HITCH
NUT, 5/16, NYLOC
WASHER, 5/16 | WASHER, 5/16 |
BOLT,
WASHER,
SPECIAL
WASHER, 5/16
BOLT,
2MOUNTING COVER ASSEMBLY TO SUPPORT ASSEMBLY
(See Figure 2)
NOTE: For ease of assembly, you may wish to obtain the assistance of another person for mounting cover assembly to mower.
1.Position cover assembly on ground behind mower as shown.
2.Lift and rotate cover to align cover brackets with support assembly tubes.
3.Slide cover assembly down onto the support tubes.
COVER
ASSEMBLY
SUPPORT
ASSEMBLY
FIGURE 1B | FIGURE 2 |
| 7 |